Loading ...
Loading ...
Loading ...
HOW TO "FliNE=TUNE" YOUR
It's not hard to "fine-tune" your softener (See
page 14), but it does take a few minutes of your
time to do it right. You may save up to 500
pounds or more or salt each year with proper
tuning. Read the following carefully.
To have soft water all the time, the softener
must regenerate 1 or more times in each 6 day
period. How many times to regenerate (set on
the time dial) and the salt saver setting to use
depends on 2 things.
1.The number of people in your home-tellsyou
how much water is used
2. The grains per gallon (GPG) hardness of your
water supply -- listed on your water analysis
report .... see page 4.
The softener regenerates with salt (brine - see
page 15)_ The pounds of salt needed each regen-
eration is set on the salt saver valve The salt
saver on your softener is set for_
.....4.7 Ibs - Model No. 625340400 Capacity 40
._5_7 Ibs_ - Model No_ 625_340500 High Cap. 50
.....7.2 Ibs.- Model No. 625..340700 Ex High Cap. 70
This setting gives you soft water for the longest
time before the next regeneration is needed.
However, you will get more gallons of soft water
for each pound of salt used if the softener is re-
generated more often at a lower salt saver set-
ting. Over a period of time, a lower salt setting
will save you salt, and money_
meeting point, pictures of the time dial and salt
saver show you the settings to use The time dial
picture shows you the button numbers to push
inward (See below)The salt saver picture shows
you the number to set your salt saver at (See
page 22).
SETTING THE TIME DIAL
FOR REGENERATIONS
The time dial (FIG 26) turns all the time and
makes 1 complete turn every 6 days It has 6
buttons numbered from 1 through 6 Buttons
pushed inward start regenerations. Buttons pulled
outward will not start regenerations
The picture of the time dial, in the regeneration
table, shows the buttons to push inward for
regenerations. Push those buttons inward Be
sure all others are outward.
SET REGENERATIONS ON THE
TIME DIAL
No 1
Button
Dot
REGENERATION TABLE: The table on page 19,
20 or 21 makes it easy for you to pick the best
regeneration arrd salt saver settings to use_
STEP 1 -- Go down the left hand side of the
table for your rnodel, to the section listing the
number of persons in your family, or the number
of people in the house using water.
STEP 2 --Acrossthetopofthetable, findthe
column listing the grains per gallon hardness of
your water.
STEP 3 --Readacrossanddownthetableto
find the point where steps l and 2 meet At this
18
NOTES:
Buttons 1, 3 and 5 were pushed inward at the
factory
If a button at the top of the dial will not push
inward, turn the dial to the right until it will
TO RESET TIME OF DAY, SEE PAGE 14,
Regenerations start at about 2:00 AM.
This timer is not made to be an accurate time
clock Sometimes, it may need resetting to the
correct time of day
Loading ...
Loading ...
Loading ...