Loading ...
Loading ...
Loading ...
108 - CLEANING AND MAINTENANCE 914779932/A
This stage is indicated by a progressive increase
in the cooking level.
End of Vapor Clean
At the end of the Vapor Clean function,
"Function ended" displays and a buzzer sounds
briefly, which can be deactivated by touching
any point of the display or by opening the door.
1. Touch the HOME button to quit the
function.
2. Proceed with draining the reservoir as
described above.
3. Open the door and wipe away the less
stubborn dirt with a microfibre cloth.
4. Use a non-scratch sponge with brass
filaments on tougher encrustations.
5. In case of grease residues use specific oven
cleaning products.
6. Remove any remaining water from the oven
cavity.
7. Where fitted, reposition the self-cleaning
panels and the rack/tray support frames.
For greater hygiene and to avoid foods taking
on unpleasant odours:
• We recommend drying the inside of the
oven with a fan assisted function at 160°C
for around 10 minutes.
• Where the self-cleaning panels are fitted,
we recommend drying the inside of the oven
with a simultaneous catalysis cycle.
Descaling
Periodically the display will show the request to
perform the boiler descaling procedure.
1. Touch the CONFIRM button to
confirm.
The appliance suggests the reservoir drain
function
.
Preliminary operations
In case there is residual water inside the
reservoir:
1. Open the door.
2. Place a jug or container on the open door.
3. Remove the loading wand from its holder.
4. Press the START button to start draining
the water into the jug (or container).
The residual water begins to drain into the jug
(or container).
We recommend wearing rubber gloves
for these operations.
For easier manual cleaning of parts that
are difficult to reach, we recommend
removing the door.
The presence of scale due to lack of
descaling can compromise correct
operation of the appliance in the long
term.
We recommend performing descaling
every time this is indicated on the
display in order to keep the boiler in
perfect operating condition.
The descaling process can be skipped
two consecutive times.
After this, the appliance will not allow
any other function to be run until a new
descaling process is performed.
Loading ...
Loading ...
Loading ...