Loading ...
Loading ...
Loading ...
Cleaning and maintenance
46
Refrigerator lamp replacement
The refrigerator lamp is below the
refrigerator thermostat; to replace:
1. Remove the protective panel using a
screwdriver.
2. Replace the lamp(s) using the same type
of lamp(s).
4.5 What to do if...
The appliance does not work:
• Make sure that the appliance is plugged
in and that the main switch is turned on.
The compressor starts to function too often
or functions continuously:
• The room temperature is too high.
• The door is being opened too often or
for too long.
• The door is not closing/sealing properly.
• The freezer is loaded with too many fresh
foods.
• Check that sufficient air can circulate
around the sensor on the right-hand side
of the refrigerator compartment.
• Check that the back of the freezer is
properly ventilated and that the
condenser is not too dirty.
Excessive ice or condensation has built up
inside the refrigerator compartment:
• The door is being opened too often or
for too long.
• Fresh food (fruit and vegetables) has
been placed inside the refrigerator
compartment.
• Food not properly covered or stored in
hermetically closed containers.
• The foodstuffs or containers are in
contact with the rear wall.
• The door seal is damaged or dirty. To
clean the seal use lukewarm water and
then dry it.
Water is forming inside the refrigerator
compartment:
• The drainage channel or opening is
blocked.
Only use C25-E14 LED bulbs,
max. 1.5 W.
After lamp replacement, wait for 5
minutes before plugging in the plug.
Loading ...
Loading ...
Loading ...