Loading ...
Loading ...
Loading ...
7
OPERATIONS MANUAL
REFRIGERATED GRIDDLE STANDS
REMOVAL OF DRAWERS
AND DRAWER ADJUSTMENTS
To remove the drawers from the cabinet, slide each drawer
out until it stops. Unhook the stop clip at the front of the left
and right-hand drawer slide (see Figure 5) by pushing the clip
forward and pressing down on the top back edge as shown. Lift
the drawer slightly as you pull it the rest of the way out. Larger
drawers may require two people. The center member, with the
wheels attached, will remain in the cabinet. To remove a drawer
center member for cleaning or maintenance, pull it out and push
up on the release lever at the back, as shown.
To install a drawer, identify the correct parts and orient the
center members so the plastic clips are in the front and at the
top. Insert one of the center members into the front of the
correct cabinet member (which is permanently attached to the
inside of the cabinet) and slide it in, until it stops. Push up on
the release lever (located toward the rear and top of the center
member) to allow the center member roll the rest of the way into
the cabinet member, in the “drawer closed” position. Repeat
for the opposite side center member. Pull each center member
out a few inches, press down on the rear of each stop clip, and
pull forward so the hook on the front of the clip rotates up, into
the “unlocked” position. Lift the drawer body into place, resting
the drawer members (the channels welded to the sides of the
drawers) on the front wheels of the center member, and slide
the drawer into the cabinet. Once the drawer goes in all the way
and slides smoothly, open it enough to access the stop clips.
Lift the back of each clip and push in at the front, so the hook
portion snaps into the “locked” position. The drawers are now
secured, so they cannot accidentally be lifted out of the cabinet.
Check that the drawer is properly aligned, rolls smoothly and the
drawer gasket seals firmly.
If the drawer fronts needs adjustment (once all drawers are
installed and closed), loosen the screws that hold the drawer
front to the drawer body. Move the drawer front into position
desired and re-tighten all screws.
REMOVAL AND REPLACEMENT OF DRAWER CAGE
Follow the instructions above to remove the drawers. Take out
the four (4) mounting screws around the inside of each opening.
Use a razor knife to carefully slit any silicone sealing the cage
frame to the cabinet. Lift the drawer cage up, above the breaker
covers, and slide it out of the cabinet. The fit is tight, so the
straighter it’s aligned, the easier it will be to remove.
Replacement is the opposite of the removal. Once the drawer
cage is in as far as it will go, the notches at the bottom front
should surround the breaker corners, the cage should be sit-
ting flat on the interior floor of the unit and the front face of the
cross mullion should be flush with the front face of the unit. This
allows the drawer gasket to seal smoothly around the drawer
opening.
With the cage in place, sitting flat on the floor of the unit and
flush with the front, reinstall the four (4) front mounting screws
in each opening, screwing through the primary breakers, and
through the metal beneath them.
FIGURE 5: Drawer Slide
SLIDE CLIP FORWARD
& PRESS HERE
TO DISENGAGE
PUSH UP ON
LEVER TO
DISENGAGE
DRAWER MEMBER
CABINET MEMBER
CENTER MEMBER
STOP CLIP
(EXPLODED VIEW)
RELEASE LEVER
LEFT-HAND SHOWN (RIGHT-HAND OPPOSITE)
Loading ...
Loading ...
Loading ...