Loading ...
Loading ...
Loading ...
To Remove and Replace
Storage Drawer (with
extended guides)
[]
push d°wn with flnP r i_kt Gild e
Figure 1
To Remove Storage Drawer:
1. Open the drawer to the fully opened position.
2. Locate the glide lever on each side of drawer; pull up on the left glide lever and
push down on the right glide lever (seefigure 1).
3. Pull the drawer away from the range.
To Replace Storage Drawer:
1. Pull the bearing glides to the front of the range (see figure 2).
2. Align the drawer glides with the slots on the bearing glides.
3. Pushthe drawer into the range until the glides levers "click" (approx. 2 in.). Pull
the drawer open again to seat it into position.
4. If you do not hear the glide levers "click" or if the drawer does not feel
seated, remove it and repeat steps 1 through 3. Doing so will minimize
damage to the bearing glides. Do not try to force the drawer into place.
Figure 2
Changing Cooktop and/
or Oven Lights
some models)
TO Change the Cooktop Light (some models)
Your model will either have a canopy cover that lifts up or 2 Phillips® Head screws
that secure the light cover. BEFORECHANGING THE COOKTOP LIGHT,BESURE
TO TURN THE POWEROFFATTHE MAIN SOURCEOR UNPLUGTHE RANGE.
For models with a canopy cover that lifts up, follow these instructions:
1. Grasp the front edge of the canopy cover as illustrated in the side column. Pull
forward and lift the cover up and off toward rear of range.
2. Remove bulb by rolling up and out. Install the new butb by sliding down into
place and rolling toward front of range.
3. Align front edge of light cover with inside lip of end cap. Lower rear of cover
into place and snap down.
4. Turn power back on at the main source (or plug the range back in).
To Change the Oven Light
The oven light automatically turns on when the door is opened (some models). To
turn the oven light on and off when the door isclosed, usethe OVEN LIGHTswitch
located on the control panel.
1. Turn electrical power off at the main source or unplug the oven.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Presswire holder to one side to releasethe glass shield.
4. Replace bulb with a new 40 watt appliance bulb.
5. Replace glass shield in socket and snap wire holder into place.
6. Turn power back on at the main source (or plug the appliance back in).
7. Theclock will then needto be reset.To reset,seeSetting the Clockand Minute
Timer in the ELECTRONICOVEN CONTROL manual.
Besurethe oven isunplugged and all parts are COOL before replacing
the oven light bulb. Do not turn the oven light on during a self-cleaning cycle. High
temperature will reduce lamp life.
23
Loading ...
Loading ...
Loading ...