Loading ...
Loading ...
Loading ...
TROUBLESHOOTING CHART:
See appropriate section in manual unless directed to Sears service center
=ROBLEM
Mower blades will
not rotate
Poor grass
discharge
Headlight(s) not
working
if so equipped)
Battery will not
charge
CAUSE
16 Obstruction in clutch
mechanism.
2. Worn/damaged mower drive
bell
3. Frozen idler pulley.
4. Frozen blade mandrel.
5 Mower belt off engine pulley
t. Engine speed too slowo
2_ Travel speed too fast.
3. Wet grass,
4. Mower not level.
5. Low/uneven tire air pressure.
6. Worn, bent or loose blade.
7. Buildup of grass, leaves and
trash under mower.
8. Mower drive belt worn.
9. Blades improperly installed,
10. improper blades used,
II
•Clogged mower vent
holes from buildup of grass,
leaves, and trash around
mandrels.
1. Light switch is "OFF",
2, Bulb(s) or lamp(s) burned out,
3. Faulty light switch.
4, Loose or damaged wiring,
5, Blown fuse,
1, Bad battery cell(s),
2, Poor cable connection&
CORRECTION
1. Remove obstruction,
2, Replace mower drive belto
3. Replace idler pulley.
4. Contact a Sears or other
qualified service center
3. install belt on engine pulley.
1_ Place throttle control in
"FAST" position,
2. Shift to slower speed.
3. Allow grass to dry before
mowing
4. Level mower_
5. Check tires for proper air
pressure,
6. Replace/sharpen blade
Tighten blade bolt.
7. Clean underside of mower
housing.
8. Replace mower drive bell
9, Reinstall blades sharp edge
down.
O.Replace with blades listed
in this manual.
1. Clean around mandrels to
open vent holes,
. Turn light switch "ON",
. Replace bulb(s) or lamp(s),
3. Check/replace light switch_
4. Check wiring and connections.
5 Replace fuse.
1_ Replace battery.
, Check/clean all connections.
Loss of drive
,
4,
1-
2,
Faulty regulator
(if so equipped).
Faulty alternator.
Freewheel control in
"disengaged" position,
Motion drive belt worn,
damaged, or broken.
3. Replace regulator.
4. Replace alternator.
I_ Place freewheel control in
"engaged" position,
2 Replace motion drive belt,.
Engine "backfires"
when turning
engine "OFF"
3,, Air trapped in transmission
during shipment or servicing.
Engine throttle control not set
between half and full speed
(fast) position before stoppinc
engine.
3, Purge transmission,
Move throttle control
between half and full speed
(fast) position before
stopping engine,
31
Loading ...
Loading ...
Loading ...