Loading ...
Loading ...
Loading ...
28 INSTALLAiTIONINSTRUCTIONS
Installation test (Duct check) (cont.)
• Check the error code before you call for service
Error Code Possible causes Solutions
• Temperature sensor failure
tel or rE2
HS • Humidity sensor failure.
• Electric dryer power cord is not
connected correctly, or house power
supply is incorrect.
• House fuse is blown, circuit breaker has
tripped, or power outage has occurred.
PS or PF or nP
• Turn off the dryer and call for
service.
• Turn off the dryer and call for
service.
• Check the power supply or the
connection of power cord to the
terminal block. Referto the
Connecting electric dryers section of this manual
for complete instructions.
• Reset circuit breaker or replace fuse. Do not increase
the fuse capacity.
If the problem isa circuit overload, have it corrected
by a qualified electrician.
• Check the duct condition
If the test displays four bars, check the exhaust system
for restrictions and damage. Repair or replace the
exhaust system as needed.
" 0 NOTE
When the dryer is first installed, this test should be
performed to alert you to any existing problems with
the exhaust duct in your home. However, since the
test performed during normal operation provides
more accurate information on the condition of the
exhaust duct than does the installation test, the
number of bars displayed during the two tests may
not be the same.
Do not interrupt the test cycle, as this could result in
inaccurate results.
Even if no bars are displayed during the test cycle,
some restrictions may still be present in the exhaust
system. Refer to the Venting the Dryer section of
this manual for complete exhaust system and venting
requirements.
Your dryer features Flow Sense TM, an innovative
sensing system that automatically detects and alerts
you to blockages and restrictions in installed house-
hold ductwork. If you see the alert, clean or repair the
ducts to remove the restrictions. Keeping ductwork
clean of lint buildup and free of restrictions allows
Restricted or blocked airflow []
Avoid long runs or runs with multiple elbows or
bends.
Excess or crushed Too many elbows or
transition duct exhaust too long
Check for blockages and lint buildup.
Lint buildup
or blockage
Make sure the ductwork is not crushed or restricted.
Crushed or
damaged
exhaust
Loading ...
Loading ...
Loading ...