Loading ...
Loading ...
Loading ...
22 49-2000650 Rev. 1
ENGLISH
CARE AND CLEANING
Removing and Cleaning the Filters
To remove, slide them to the rear using the tabs. Pull down
and out.
To clean the vent filters, soak them and then swish around
in hot water and detergent. Don’t use ammonia or ammonia
products because they will darken the metal. Light brushing
can be used to remove embedded dirt.
Rinse, shake and let dry before replacing.
To replace, slide the filters into the frame slots on the back of
each opening. Press up and to the front to lock into place.
Cooktop Lights/Nite Lights
Replace with DC12 volt, 1.2 watt LED lights. Order
WB25X33469 from your Haier supplier.
1. To replace the cooktop lights/nite lights, first disconnect
the power at the main fuse or circuit breaker panel, or
pull the plug.
2. One side at a time, remove the screw from the side of the
light compartment cover and lower the cover until it stops.
3. Be sure the LED light is cool before removing. Gently
remove the LED wiring connector from LED board.
4. Replace with the new LED board and insert the wiring
plug, then raise the light cover and replace the screw.
Repeat for the other light. Connect electrical power to
the oven.
Remove screws.
Vent Fan
The vent fan has two metal reusable vent filters.
Models that recirculate air back into the room also use a
charcoal filter.
Reusable Vent Filters
The metal filters trap grease released by foods on the
cooktop. They also prevent flames from foods on the
cooktop from damaging the inside of the oven.
For this reason, the filters must always be in place when
the hood is used. The vent filters should be cleaned once
a month, or as needed.
Reusable vent filters
(on all models).
Charcoal filter
(on some models).
Replacing the Oven Cavity Lamp
1. Disconnect power at the main fuse or circuit breaker
panel.
2. Press the charcaol access door at the top to open.
3. Remove charcoal filter if present. NOTE: Charcoal filter
is an optional kit, you may not have one.
4. Press the retainer holding the lamp shield in place.
5. Pull the lamp shield out. Unscrew the LED light out and
replace with the new LED board. Order WB25X33469
from your Haier supplier.
6. Return the lamp and lamp shield to original position and
replace charcoal filter.
7. Reconnect power to the oven.
Loading ...
Loading ...
Loading ...