Loading ...
Loading ...
Loading ...
• Assemble the hitch bracket to the tongue using two
3/8" x 1" hex bolts (D), and two 3/8" nylock nuts (l)
Tighten. See figure 7
• Assemble the hitch pin (G) through the hitch bracket
and the tongue Secure the hitch pin with the large
hairpin cotter (F). See figure 7.
HITCH
PIN (G) 3/8" x 1"
HEX BOLT(D)
// //
; :: _ 3/8 NYLOCK
NUT(I)
HITCH -- LARGE HAIRPIN
BRACKET COTTER (F)
FIGURE 7
• Assemble a whee{ to a wheel bracket as shown in
figure 9. Use a 1/2" x 3-1/2" hex bolt (A), one 1/2"
hex iam nut (L), and one 1/2" ny]ock jam nut (H).
Adjust the nuts so that the wheel is held securely with
minimum end play but will spin freely. Repeat on other
side• See figure 9.
1/2" NYLOCK
JAM NUT (H)
1/2" JAM NUT (L)
FIGURE 9 UPSIDE DOWN ViEW
• Turn the tray upside down Standing behind the tray,
place the long end of the shaft through the end plate
on your dght as shown in figure 8. Place the other end
of the shaft through the end plate on your left. Make
sure the bent end of the middle brace rests flat inside
the tongue.
• Assemble a 3/4" flat washer (N) and a wheel bracket
onto each end of the shaft. Turn each wheel bracket
to point in the opposite direction from the lift lever
Secure each wheel bracket with a 1/4" x 1-3/4" hex
bolt (B) and 1/4" nylock nut (K). Tighten See figure 8.
NUT (K)
LIFT LEVER
FIGURE 8
3/4" FLAT
WASHER (N)
1/4" x 1-3/4"
/
_ HEX BOLT (B)
UPSIDE DOWN VIEW
Tip the aerator onto the back edge of the tray Fasten
the middle brace to the bottom of the tongue using
two 3/8" x 1" hex bolts (D) and 3/8" nylock nuts (I). Do
not tighten until final step• See figure 10.
_g JJ
MIDDLE
BRACE
FIGURE 10
Loading ...
Loading ...
Loading ...