Loading ...
Loading ...
Loading ...
4. If you are installing your keg refrigerator under a
counter you will need to drill 5 holes in the counter top
to mount the tower.
1
⁄2" diameter
hole located at the center of the tower for the beer
line, locate approximately 13
1
⁄2" (34.3 cm) from the
front edge of the counter top (based on a counter top
depth of 25
5
⁄16"). Next drill the 4 tower mounting holes
per the dimensions in Figure 22. The hole diameter is
depen-dent on the counter top material and if screw
anchors are required. The screws supplied are in the
literature pack and are a #10 x 1" type AB stainless
steel screw. Mark and cut the rectangular cut out for
the drain sump. After the holes are drilled and the keg
refrigerator is in place under the counter top feed the
beer line through the tower gasket, the 1
1
⁄2" hole in the
counter top and the hole in the top of the keg
refrigerator. Mount the tower to the counter top with
the 4 screws provided.
5. Mount the regulator to the CO
2 tank (connection
B
).
Note that the regulator has left hand threads and has
to be turned counterclockwise to tighten. Tighten with
the adjustable wrench or the 1
1
⁄8" open end wrench.
6. Connect the red air line(s) from the regulator to the
large large
hose clamp (connection
C
).
7. Connect the clear beer line from the tower to the
small small
hose clamp (connection
A
).
12
Diameter
to suit
Rear of counter top
2
7
⁄8"
(7.3 cm)
1
3
⁄8"
(3.5 cm)
typical
1
1
⁄2 (38 mm)
Diameter
counter
top depth
25
5
⁄16"
(64.3 cm)
Figure 22
Figure 23
Figure 24
Tower
!
CAUTION
USING YOUR BEER DISPENSER
4¼”
(10.8 CM)
6⅜”
(16.2 CM)
6⅛”
(15.6 CM)
12¼”
(31.1 CM)
¼” (6 MM)
radii,
typical
The cutout dimensions shown in Figure 22 are based on a
25
5
⁄16" (64.3 cm) deep counter top. Your counter top may
be different than this and require other front to back dimen-
sioning. Refer to the product dimensions on page 8 when
determining the required dimensions.
Grate from
top of beer
dispenser
Counter top
sump from
literature pack
Loading ...
Loading ...
Loading ...