Loading ...
Loading ...
Loading ...
INSTALL AND ADJUST THE D-HANDLE
(nsta((
1. Place the D-handle down on to the shaft housing and
the bottom clamp so that the handle slants towards
the shaft grip (Fig. 1). Place handle and clamp a
minimum of 6 inches from the end of the shaft grip.
2. Start screws with a large Flat-head or T-25 Torx
screwdriver. Do not tighten until you make the handle
adjustment.
Install the screws with a Phillips screwdriver (Fig. 4).
/
Recessed
Pocket
CuttingAttachment
ShieH
F_g.3
Bottom Clamp
F_g. 1
Adjust
3. While holding the unit in the operating position,
position the D-handle to the location that provides
you the best grip.
4. Tighten the clamp screws evenly until the D-handle is
secure.
INSTALL THE CUTTING ATTACHMENT SHIELD
WARNING: Neveroperate the
trimmer without the
cutting attachment shield in place to
prevent serious personal injury,
Use the following instructions if the cutting attachment
shield on your unit is not installed.
1. Place the cutting attachment shield onto the shaft
housing above the clamp assembly (Fig, 2).
2. Lower the cutting attachment shield down to the top of
the cutting attachment assembly and then rotate the
cutting attachment shield until the screw holes align
and the guard fits into the recessed pocket (Fig, 3),
F_g. 4
EDGE GUmDE WHEEL
1. Push edge guide wheel onto the shaftjust above the
cutting attachment shield (Fig, 5). Some force may be
required. The depth adjustment nut must be on top.
2. Install the bolt, washer and wing nut. Tighten securely.
3. Adjust the edging depth by loosening the depth
adjustment nut. Then move the guide wheel along the
path shown by the arrows (Fig. 5) until the wheel
reaches the desired position and then tighten securely.
For instructions on how to operate the edge guide wheel,
refer to page 11.
Wing Nut
\
\
\
F_g. 2
Depth
Adjustment
Nut
Edge Guide
Wheem
7 Fig. 5
Loading ...
Loading ...
Loading ...