Loading ...
Loading ...
Loading ...
Exit Needle
Remove the pod holder assembly and detach
the funnel. Locate the exit needle on the inside
bottom of the K-Cup
®
pod holder. Insert a
straightened paper clip into the exit needle
to loosen the clog and push it out.
Entrance Needle
Lift the brewer handle and locate the
entrance needle on the underside of the
brewer head. To clean all three holes in the
needle, hold the brewer handle in the upward
position and with your other hand, carefully
insert a straightened paper clip into all three
holes. Gently move it around to loosen any
coffee grounds. Lower the handle completely
and run two water-only brew cycles. Do not
insert a K-Cup
®
pod.
TIP: Refer to support.keurig.com for video instructions on cleaning the
entrance/exit needles.
K-Cup
®
Pod Holder Assembly
To remove the K-Cup
®
pod holder
from the brewer, lift the handle and
grasp the top of the K-Cup
®
pod
holder with one hand while pushing
up on the bottom of the K-Cup
®
pod
holder from underneath with the
other until it releases. To reinstall,
align the K-Cup
®
pod holder with the
opening using the two front ribs as
a guide and snap into place from
the top.
CAUTION: There are sharp needles that puncture the K-Cup
®
pod
above the K-Cup
®
pod holder and in the bottom of the K-Cup
®
pod
holder. To avoid risk of injury, do not put your fingers in the K-Cup
®
pod holder.
Funnel
The funnel can be removed from the
K-Cup
®
pod holder by pulling on it
until it pops off. To replace it, orient
the snaps to the indent and just
snap it back onto the K-Cup
®
pod
holder.
Caring for your Brewer (continued)
Loading ...
Loading ...
Loading ...