Craftsman 358795190 trimmer

User Manual - Page 13

For 358795190.

PDF File Manual, 19 pages, Download pdf file

Loading ...
Loading ...
Loading ...
causeseriousinjury.Donotuseother
materialssuchaswire,string,rope,
etc.Wirecanbreakoffduringcutting
andbecomea.dangerousmissilethat
cancauseseriousinjury.
CUTTINGMETHODS
_WARNING:Useminimum
speedanddonotcrowdthelinewhen
cuttingaroundhardobjects(rock,
gravel,fenceposts,etc.), which can
damage the trimmer head, become
entangled in the line, or be thrown
causing a serious hazard.
The tip of the line does the cutting.
You will achieve the best perform-
ance and minimum line wear by not
crowding the line into the cutting
area. The right and wrong ways are
shown below.
Tip ofthe Une Line Crowded Into
Does The Cutting Work Area
Right
The line will easily remove grass
and weeds from around walls,
fences, trees and flower beds, but it
also can cut the tender bark of trees
or shrubs and scar fences.
For trimming or scalping, use less
than full throttle to increase line life
and decrease head wear, especially:
During light duty cutting.
Near objects around which the line
can wrap such as small posts,
trees or fence wire.
For mowing or sweeping, use full
throttle for a good clean job.
TRIMMING - Hold the bottom of the
trimmer head about 3 in. (8 cm) above
the ground and at an angle. Allow only
the tip of the line to make contact. Do
not force trimmer line into work area.
Trimming
x
3 in. (8 cm)
Above Ground
SCALPING - The scalping technique
removes unwanted vegetation down
to the ground. Hold the bottom of the
trimmer head about 3 in. (8 cm) above
the ground and at an angle. Allow the
tip of the line to strike the ground
around trees, posts, monuments, etc.
This technique increases line wear.
Scalping
MOWING - Your trimmer is ideal for
mowing in places conventional lawn
mowers cannot reach. In the mowing
position, keep the line parallel to the
ground. Avoid pressing the head into
the ground as this can scalp the
ground and damage the tool.
Mowing
_J")}I),
SWEEPING - The fanning action of
the rotating line can be used to blow
away loose debris from an area. Keep
the line parallel to and above the area
surface and swing the tool from side
to side.
Sweeping
13
Loading ...
Loading ...
Loading ...