Loading ...
Loading ...
Loading ...
TUBE ASSEMBLY
o Loosen screws in the housing clamp.
• Remove and discard shipping plug,
° Nign the groove in the lower tube
with the ridge in the housing; insert
the tube intothe housing. FIRMLY
PUSH LOWERTUBE INTO HOUSING
UNTIL THE BOLDLINE ON THE DECAL
IS NOTVISIBLE (about 2-1/4 inches),
• Securely tighten the screws in the
housing clamp,
LowerTube
E_ld Line
On Decal
HousingClamp
Shipping Plug
NOTE: When performing the following
step, be sure the handle is aligned as
follows: label on top, throttle trigger to
the operator's right hand side. The
starter rope and throttle cable must not
wrap around the tube.
Throttle_abe|
Trigger
• Assemble handle tube to the lower
tube (itwill be necessary to pull some
of the starter rope out of the housing).
, Align the screw holes; insert the
screws through the aligned holes.
° Thread one Iocknut onto each screw
and tighten securely.
Handle Tube
Screws
.\
Lower
Tube
\
Starter Rope
Locknuls
NOTE: When performing the following
step, be sure the starter rope is not
caught under the cable clamp. The
starter rope must hang freely to oper-
ate properly,
• Align the cable clamp between the
tube screws. Install the cable clamp
around the tube and throttle cable.
Loading ...
Loading ...
Loading ...