Loading ...
Loading ...
Loading ...
7
Copper Tubing (3/8" [9.5 mm]
O.D. suggested) or Flexible
Braided Water Supply Line Kit.
Screw-Type Clamps
1
1
/
2
"–2" (38 mm – 50 mm)
(3 maximum)
Optional – Longer Drain
Hose Maximum length 12 ft
(3.7 m)
NOTE: Must meet AHAM/
IAPMO test standards, fit
1" (25 mm) drain connection,
and be resistant to heat and
detergent.
NOTE: Be sure to purchase only Whirlpool factory-certified parts
and accessories for your appliance. Your installation may require
additional parts. To order, refer to the contact information
referenced in your Quick Start Guide.
NOTE: If using a flexible braided hose, replace inlet hose after
5 years to reduce the risk of hose failure. Record hose installation
or replacement dates on the hose for future reference.
For Direct Wire For Power Cord
Cabinet Grommet
For 1
1
/
2
" (38 mm) hole in
cabinet
NOTE: Required for metal
cabinets
Power Cord Kit
Kit typically includes power
cord, metallic strain relief,
grommet, and twist-on wire
connectors (Straight: Whirlpool
Part Number 4317824, 90°:
Whirlpool Part Number
W10278923RP). For proper
installation, refer to the
installation instructions
provided with the kit.
NOTE: Be sure to purchase only Whirlpool factory-certified parts
and accessories for your appliance. Your installation may require
additional parts. To order, refer to the contact information
referenced in your Quick Start Guide.
Location Requirements
Dishwasher must be fully enclosed (top, sides, back, and floor)
upon installation. A side panel kit is available from your dealer for
installing your dishwasher at the end of your cabinetry.
An optional moisture barrier accessory is also available for
installing underneath a wooden countertop.
Check location where dishwasher will be installed. The location
must provide:
n Convenient access for loading and unloading dishes. Corner
locations require a 2" (51 mm) minimum clearance between
the side of the dishwasher door and the wall or cabinet.
n Easy access to water, electricity, and drain:
• Grounded electrical supply is required.
• This dishwasher has a water-heating feature and also
requires a connection to a hot water supply line.
• Make sure pipes, wires, and drain hose are within the
shaded area shown in the “Cabinet Opening Dimensions”
section.
• Do not run drain lines, water lines, or electrical wiring where
they can interfere with or contact dishwasher motor or legs.
• Shelter dishwasher and water lines leading to dishwasher
against freezing. Damage from freezing is not covered by
the warranty.
NOTE: If dishwasher will be left unused for a period of time
or in a location where it may be subject to freezing, have it
winterized by authorized service personnel.
• If installed in new construction, flush the water supply line of
debris before connecting it to the fill valve. If it is not
flushed, debris from the water supply could plug the fill
valve screen.
n A square opening for proper operation and appearance.
n The cabinet front to be perpendicular to floor.
n A level floor.
Helpful Hint: If floor at front of opening is not level with floor at
rear of opening, shims may be used to level dishwasher.
NOTE: To avoid shifting during dishwasher operation, shims must
be securely attached to the floor.
n The location where the dishwasher will be installed must
provide clearance between motor and flooring. Motor should
not touch the floor.
n Do not install dishwasher over carpeted flooring.
Loading ...
Loading ...
Loading ...