Jenn-Air 1169168 2 Piece Kitchen Appliances Package with JDRP436HM 36 Inch Dual Fuel Gas Range and JXW8736DS 36 Inch Wall Mount Recirculating Hood in Stainless Steel

User Manual - Page 15

For 1169168.

PDF File Manual, 40 pages, Read Online | Download pdf file

1169168 photo
Loading ...
Loading ...
Loading ...
15
Timer
The range hood can be set to automatically turn off after
15 minutes.
1. Press and hold the desired fan speed button for 2 seconds.
The fan will run on the chosen speed for 15 minutes and the
fan speed button light will flash continuously.
After 15 minutes, the fan will turn off automatically.
2. Press the desired fan speed button again while the fan timer
is running to cancel the fan timer.
NOTE: Changing the fan speed or turning Auto Sense on will
also cancel the 15-minute timer.
Filter
The Filter button lights up when it is time to replace or clean the
filter. The button will be lit only when the fan is on. Press FILTER
after replacing the filter to turn the Filter button light off. See the
“Cleaning” section for how to replace or clean the filter.
Light
Press LIGHT to turn the range hood lights on and off.
RANGE HOOD CARE
Cleaning
IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions. Replace grease filters
before operating hood.
Exterior Surfaces:
To avoid damage to the exterior surface, do not use steel wool
or soap-filled scouring pads.
Always wipe dry to avoid water marks.
Cleaning Method:
Liquid detergent soap and water, or all-purpose cleanser:
Wipe with damp soft cloth or nonabrasive sponge, then rinse
with clean water and wipe dry.
Metal Grease Filters
The filter should be washed frequently. Place the metal filter in
the dishwasher or hot detergent solution to clean.
Let the filter dry thoroughly before replacing it.
NOTE: The metal grease filter is located behind the center metal
filter cover. The panel is magnetically secured along the front
and has a tab along the back to hold the filter cover in place. To
access the grease filter, grasp the panel on the front corners and
pull down. This releases the panel from the magnets and allows
the panel to swing down. Pull the alignment tab on the filter
cover out of the alignment slot on the range to remove.
A. Slot for filter cover alignment
B. Filter cover magnets
C. Filter cover
D. Tab on filter cover for alignment
A
B
C
D
Loading ...
Loading ...
Loading ...