Loading ...
Loading ...
Loading ...
MAINTENANCE INSTRUCTIONS
Attach the rear hanger plates to the hole that
most closely aligns with the pin on the deck lift
bracket. Secure with washer and hair pin.
/h[ i !! !!ii! iiiii!i i ii! !i!!!i! !i Iiiiic i! !i ! Ni i ii!i Mii iii iii ii i i i i i i iiiiiiiiiiiiiii!j/hi
Make certain sectorplatesare mountedin the same I
holes on each side for proper frontto rear level J
FRONT OF TRACTOR
Adjust the swivel on the front lift rod until it
lines up with the hole in the front lift bracket.
(make sure the lift rod is at the top of the slot in
the deck bracket) Secure with hair pin.
FRONT TO REAR LEVEL
Position the blades as shown in Fig. 70d.
Measure the distance from the left front blade
tip to the ground and from the right rear blade
tip to the ground. The front left blade tip should
be between 1/8" and 3/8" higher than the right
rear (factory setting). If it is between 1/8" and
3/8" you are finished with adjustment.
If it is not within specifications, adjust by raising
or lowering the front of the deck using the
the swivel on the front lift rod. Turning the swivel
clockwise will raise the front of the deck. Turning
the swivel counter-clockwise will lower the front of
the deck.
BLADE TIP
\
\
RIGHT REAR BLADE TIP
FIGURE 70d
BLADESORIENTATEDFORFRONT-TO-REAR
LEVELCHECK
NOTE:
The deck should be set sothat the rear of the deck is 1/4"
lowerthan the front. See Fig. 70e.
33" DECK SHOWN
FRONT
JL MEASURE FROM
BLADE TIPS TO FLOOR
REAR
FIGURE 70e
X
f
33B
Loading ...
Loading ...
Loading ...