Loading ...
Loading ...
Loading ...
INSPECT MUFFLER AND SPARK
ARRESTING SCREEN
'_kWARNING: The muffler on this
product contains chemicals known to
the State of California to cause cancer.
_WARNING: Muffler is very hot
during and after use. Do not touch the
muffler or allow combustible material
such as dry grass or fuel to do so.
As your unit is used, carbon deposits
build up on the muffler and spark ar-
resting screen. For normal homeown-
er use, however, the muffler and spark
arresting screen will not require any
service.
After 50 hours of use, we recommend
that your muffler be serviced or re-
placed by your Sears Service Center.
REPLACE SPARK PLUG
Replace the spark plug each year to
ensure the engine starts easier and
runs better. Set spark plug gap at
0.025 inch. Ignition timing is fixed and
nonadjustable.
1. Twist, then pull off spark plug boot.
2. Remove spark plug from cylinder
and discard.
3. Replace with Champion RCJ-6Y
spark plug and tighten securely
with a 3/4 inch socket wrench.
4. Reinstall the spark plug boot.
LINE REPLACEMENT
Always use Craftsman replacement
line.
Choose the line size best suited for
the job at hand. Red line is designed
for cutting grass and small weeds.
The black colored line is designed for
cutting larger weeds and light brush.
NOTE: Before inserting new line into
the holes in the cutting head, identify
the proper holes. Follow directions as
shown on the line glide plate.
1. Remove the old line and line glide
plate from the cutting head.
2. Clean entire surface of cutting
head.
3. Reinstall line glide plate (see il-
lustration). Align arrowwith:
(_) when using medium (red) or
large (black) line
when using lines with diameter
(_ smaller than medium (red) line
(optional)
Line glide Arrow
4. Insert both ends of your line
through the proper holes in the
side of the cutting head.
Positioning
Tunnel
5. Pull the line and make sure the
line is against the hub and ex-
tended full through the positioning
tunnels.
Line against
Positioning
Tunnel \
Cutting head
6. Correctly installed line will be the
same length on both ends.
NOTE: Line glide plate must be rein-
stalled in cutting head before inserting
new line.
15
Loading ...
Loading ...
Loading ...