Loading ...
Loading ...
Loading ...
Now start...
Excessive Weight Hazard
Use two or more people to move
and install washer.
Failure to do so can result in back
or other injury.
Usa now hoses and washers that came
with your Whirlpool washer.
Replace inlet hoses after 5 years of use
to reduce the risk of hose failure,
Inspect and replace inlet hoses if
bulges, kinks, cuts, wear, or leaks are
found, When replacing your inlet hoses,
mark the date of replacement on the
label with a permanent marker,
shipping
lm Remove tape that covers
shipping strap, Pull to
completely remove the shipping
strap with 2 coifferpins from the inside
of the washer,
coupling washer
mInsert a flat washer into each end
of the inlet hoses, Check that washers
are firmly seated in couplings,
Inletsare plastic.
Do Not stripor
cressthread.
\
mPlace ho_e clamp over washer
drain connector, Push drain hose onto
washer connector, Use pliers to open
clamp and slide clamp over drain
hose, Check for good fit,
dill
_D • Measure and mark a point
approximately 16 inches (40,6 cm)
from the plug end of the shipping
strap, Cut this shipping strap at this
point,
cold Chock that hoso is not
water twisted or kinked and is
inlet socuroly in placo.
vaive
Put "hook" end of drain
hose into standpipe,
Tightly wrap the shipping
strap around the
Pull firmly to remove the end of
shipping strap from the back of the
washer, The shipping strap plug must
be completely removed from the
washer for the self-leveling legs to
be released,
hotwater
inletvalve
standpipe, Push plug into
the nearest hole in the
shipping strap,
;3' 7=g ore
| •Altach hose to boltom inlet aiffaching water
valve opening first, Then second hose inlet hoses, run
to top inlet, Tighten couplings by water through =
hand; then use pliers to make an both faucets into _'iit
additional two-thirds turn, a bucket, This will
get rid of particles
in water lines that
might clog hoses,
Mark which isthe hot water faucet,
_;•Altach boiffom hose (inlet
marked "H') to hot water faucet,
Affach top hose (inlet marked "C') to
cold water faucet, Tighten coupling
to faucet by hand; then use pliers to
• Move washer close to final make final two-thirds turn,
Save tho shipping strop for uso in
Step 6.
position, Put "hook" end of drain hose
into standpipe, Estimate length of
drain hose needed when washer is in
final position, Hose must be cut
exactly to length so "hook" end is
held tightly over edge of standpipe, If
drain hose istoo long, cut straight end
of hose, (Do Not cut "hook" shaped
and of drain hose.)
DO NOTFORCEEXCESSLENGTHOF
DRAINHOSEDOWN THESTANDPIPE.
THISCOULDCAUSESIPHONING.See
Step 6.
dllk
UP •Stack two corner posts on top of
each other, Tiltwasher backwards and
insert corner posts 3 inches (7,6 cm) in
from one side of washer as shown,
Repeat with other corner posts on other
side of washer,
PAGE 4
Loading ...
Loading ...
Loading ...