Loading ...
Loading ...
Loading ...
16
STORAGE
Immediately prepare your lawn mower for
storage at the end of the season or if the
unit will not be used for 30 days or more.
LAWN MOWER
When lawn mower is to be stored for a
period of time, clean it thor oughly, remove
all dirt, grease, leaves, etc. Store in a
clean, dry area.
1. Clean entire lawn mower (See
“CLEANING” in the Maintenance sec-
tion of this manual).
2. Lubricate as shown in the Main te-
nance section of this manual.
3. Be sure that all nuts, bolts, screws,
and pins are securely fas tened. In-
spect moving parts for damage, break-
age and wear. Replace if necessary.
4. Touch up all rusted or chipped paint
surfaces; sand lightly before painting.
HANDLE
You can fold your lawn mower handle for
storage.
1. Remove bolts and nuts.
2. Squeeze the bottom ends of the
lower handle toward each other until
the lower handle clears the handle
bracket, then move handle forward.
3. Loosen upper handle mounting bolts
enough to allow upper handle to be
folded back.
IMPORTANT: When folding the handle
for storage or transportation, be sure to
fold the handle as shown or you may
damage the control cables.
• When setting up your handle from the
storage position, the lower han dle will
automatically lock into the mow ing
position.
Lower handle
SQUEEZE
TO FOLD
ENGINE
FUEL SYS TEM
IMPORTANT: It is important to prevent
gum deposits from forming in essential
fuel system parts such as carburetor, fuel
filter, fuel hose, or tank during storage.
Alcohol blended fuels (called gasohol or
using ethanol or methanol) can attract
moisture which leads to separation and
formation of acids during storage. Acidic
gas can damage the fuel system of an
engine while in storage.
• Empty the fuel tank by starting the en-
gine and letting it run until the fuel lines
and car bu re tor are empty.
• Never use engine or carburetor cleaner
prod ucts in the fuel tank or permanent
damage may occur.
• Use fresh fuel next season.
NOTE: Fuel stabilizer is an acceptable
alternative in min i miz ing the formation of
fuel gum deposits during stor age. Add
stabilizer to gasoline in fuel tank or stor-
age container. Always follow the mix ratio
found on stabilizer container. Run engine
at least 10 min utes after adding stabilizer
to allow the stabilizer to reach the car-
buretor. Do not empty the gas tank and
carburetor if using fuel stabilizer.
MOWING
POSITION
Lower handle
Operator
presence
control bar
Upper
handle
Handle
knob
FOLD
FORWARD
FOR
STORAGE
Nut
Bracket
Bolt
29
Ajustador
de la rueda
Clavija de montaje del puntal del mango
Bisagra
de la
puerta
traser
Aceite
del
motor
MANTENIMENTO
RECOMENDACIONES GENERALES
La garantía de esta segadora no cubre los
artículos que han estado sujetos al abuso o a
la negligencia del operador. Para recibir todo
el valor de la garantía, el operador tiene que
mantener la segadora según las instrucciones
descritas en este manual.
Hay algunos ajustes que se tienen que hacer
en forma periódica para poder mantener su
unidad adecuadamente.
Al menos una vez cada estación comprobar
si es necesario efectuar los ajustes descritos
en las secciones de Servicio y Ajustes de este
manual.
• Una vez al año, cambie la bujía, limpie o
cambie el elemento del filtro de aire y revise
si la cuchilla está desgastada. Una bujía
nueva y un elemento del filtro de aire limpio/
nuevo aseguran la mezcla de aire-com bus-
ti ble adecuada y ayudan a que su motor
funcione mejor y que dure más.
• Siga el programa de mantenimiento en este
manual.
ANTES DE CADA USO
• Revise el nivel del aceite del motor.
• Revise si hay sujetadores sueltos.
LUBRICACIÓN
Mantenga la unidad bien lubricada
(vea la “TABLA DE LUBRICACIÓN”).
TABLA DE LUBRICACIÓN
Rocie el lubricante
Vea "MOTOR" en la seccion de Mantenimiento
IMPORTANTE: No aceite o engrase los roda-
mientos de la rueda de plastico. Los lubrican-
tes viscosos atearan polvo y mugre, lo acortara
la duracion de los rodamientos autolubrican-
tes. Si cree que tienen que lubricarse, use
losamente un lubricante tipo crafito, de polvo
seco, en forma moderada.
Puerta
de la
acolchadora
Loading ...
Loading ...
Loading ...