Loading ...
Loading ...
Loading ...
I : ITORING THE CLOTHES WASHER
Washers can be damaged if water is not removed from hoses
and internal components before storage. Prepare the washer
for storage as follows:
• Select the Quick Wash cycle and add bleach to the
automatic dispenser. Run the washer through the cycle
without a load.
• Turn the water faucets off and disconnect the inlet hoses.
Disconnect the clothes washer from the electrical
supply and leave the washer door open to let air
circulate inside the tumbler.
If the washer has been stored in below-freezing
temperatures, allow time for any water left over in the
washer to thaw out before use.
For information on long-term storage or storage of your
washer during extreme cold temperatures,
call Customer Service toll-free at
1-800-843-0304 USA or 1-866-587-2002 Canada.
ROUBLESHOOTING
CHECK THESE POINTS IF YOUR WASHER...
Freshening your • See Cleaning the Interior, page I I.
washer
• Make sure door is firmly closed.
The washer will not • Make sure the washer is plugged in.
start • Make sure the water source faucets are turned on.
• Make sure to press the Cycle Selector dial to start the washer.
• Make sure the Control Lock is not activated, see page 6.
• Before the washer Starts to fill, it will make a series of clicking noises tO check the door loci<
and do a quick drain.
No water or Turn both faucets on fully.
insufficient water Make sure the door is tightly closed.
supply Make sure the washer is plugged in.
Check fuse or reset circuit breaker.
Press the Cycle Selector dial to start the washer.
Straighten water inlet hoses.
Disconnect hoses and clean screens. Hose filter screens may be plugged.
Open and close the door, then press the Cycle Selector dial.
Detergent remains in • Make sure the washer is running with sufficient water pressure.
the automatic See Installation Instructions.
dispenser after the • Make sure the Detergent Selector is in the upper position when using granular detergent.
wash cycle is complete
Washer vibrates or • Make sure the washer is set on a level surface. If the surface is not level, adjust the washer
is too noisy feet to level the appliance. See Installation Instructions.
• Make sure that the shipping bolts are removed. See Installation Instructions.
• Make sure the washer is not touching any other object.
• Make sure the laundry load is balanced.
CONT.
12
Loading ...
Loading ...
Loading ...