Loading ...
Loading ...
Loading ...
26
Troubleshooting
You may save time and money by checking items below before calling for service. List includes common concerns that are
not the result of defective workmanship or materials. If your question is not explained below, contact Amana Consumer Affairs
Department at 800-843-0304.
OPERATION
Topic
Appliance not working
Self clean shuts off
during cycle
Surface burner does not ignite
Broil cycle stops
Clock and timer not working
Oven light not working
Oven door will not unlock
Oven not clean after a
self clean cycle
Surface burner flame not
uniform around burner cap
Surface burner flame color
different than previously
owned unit
Pans rock on surface
burner grates
Locked light displayed
Display flashing
F-(numeric) display
Oven smokes the first few
times used
Surface burners work while
oven burners do not
Solution
Make sure appliance is plugged in.
Verify that circuit breaker is not tripped.
Replace household fuse but do not change fuse
capacity.
Allow oven to cool for automatic lock to disengage.
Once oven has unlocked, set oven to desired
temperature.
Surface burners should not be used during a self
clean cycle. Set self clean cycle to delay when
range does not need to be used.
Turn control to OFF and follow directions in Placing
Burner Cap section.
Turn control to OFF and follow directions in Care
and Cleaning section.
Oven door must be closed during a broil cycle.
Close oven door and broil cycle should resume
normally.
Make sure appliance is plugged in. Verify that
circuit breaker is not tripped. Replace fuse but do
not change fuse capacity.
Check for loose bulb. Tighten.
Check for burnt out bulb.
Replace if necessary with an appliance bulb.
Allow cycle to complete or cancel function.
Will not unlatch until a certain cooler temperature
has been reached. Do not force door open—will
void warranty. May blow cooler air on latch with hair
dryer at cool setting to quicken process.
Wipe out and remove excess soil prior to running
self-clean cycle.
Normal. Wipe out with damp cloth.
Normal appearance, refer to page 6 of the owner’s
manual.
Normal appearance, refer to page 6 of the owner’s
manual.
Contact installer, refer to page 6 of the owner’s
manual.
Refer to page 6 of the owner’s manual.
See Utensil section to check pan for flat bottom.
If oven is hot, allow to cool rather than trying to
force door open.
Press CLOCK.
Shut off power to oven for three minutes by
switching off circuit breaker. Reset breaker. If
continues, contact service department.
Minor smoking is normal the first few times the
oven is used. Performing a self-cleaning cycle
should stop further smoking.
Contact installer.
Possible Cause
Power outage
Oven door locked
Using surface burners during
self clean cycle
Poor cap placement
Dirt or debris on electrode
Oven door open
Power outage
Loose bulb
Burnt out bulb
Oven is self-cleaning
Oven still hot
Too much soil, grime left in
oven
Soot remains in oven after
cycle
Normal appearance
Normal appearance
Unit converted to LP without
properly adjusting shutters
Shutters out of adjustment
Warped pans
Door locked
Power failure reset clock
Service code
Normal
Valve located under
unit in RH rear section
inadvertently cut off
during installation.
Loading ...
Loading ...