Loading ...
Loading ...
Loading ...
i ΒΈ / / /
Setting Clock Minute Timer (some models)
Note: The Electronic
Time of Day clock
graphics shown vary
by model.
f
":" Flashing indicates
Minute Timer mode
To Set the 4 Button Time of Day Clock (some models)
When the range is first plugged in, or when the power supply to the range has been interrupted, "12:00" will flash in the display
window.
1. Push @.
2. Push in and hold O or O until the correct time appears in the display. O Increases time and Ot decreases time.
To Set the 4 Button Minute Timer
1. Push _,_:_wi_lappearinthedisp_aywind_w.Thetimercanbesetf_ranyam_unt_ftimefr_m_:_1 minuteto12:00
hours.
2. Push in and hold 0 until the correct amount oftime appears in the display. 0, Increases time and 0 decreases time.
The minute timer will automatically start when the button is released. The ":" will flash to indicate Minute Timer mode.
3. When the set time has passed, the control will display "0:00" and beep three times. The timer will continue to beep until
_or _ is pressed at which time the timer will return to the clock mode.
Note: Push _ at any time to cancel the timer and return to the clock operation.
Always select cookware that is suitable for the amount and type of food being prepared. Select a burner and flame size
appropriate to the pan. Never allow flames to extend beyond the outer edge of the pan.
Each burner lights automatically from either an electric ignitor or standing pilot, depending on your model. Standing pilots must
be lit initially. Refer to your installation instruction book for directions on lighting the standing pilot. Standing pilots will remain
lit when the burners are turned off. Models with electric ignitors light automatically each time a control knob is turned to the
LITE position.
Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on
top of the range when it is in use. These items could melt or ignite. Potholders, towels or wood spoons could catch fire
if placed too close to a flame.
ELECTRIC IGNITION MODELS ONLY Intheevent ofan electrical power outage, the surface burners can be litmanually.
To light a surface burner, hold a lit match totheburner head, then slowly turnthe Surface Control knob toLITE. After burner
lights push in and turn knob to desired setting. Use CAUTION when lighting surface burners manually.
Loading ...
Loading ...
Loading ...