Loading ...
Loading ...
Loading ...
Care & Cleaning
Main Top
To Raise and Lower the Top for Cleaning
1. Remove burner grates and spillover bowls. Set aside.
2. Grasp the sides of the cooktop and then lift from the front.
3. Lift the top high enough to allow the support rods to snap into place. The Lift-
up rods will support the top in its raised position.
4. Clean underneath using hot, soapy water and a clean cloth; then, dry.
5. To lower the range top, grasp the front corner of each side of the top while
pushing back on each rod with the heel of your hand. This will release the
notched support. Hold the range top and gently slide the range top down to the
range.
When lowering the top, grasp the sides with fingertips only. Be careful not to pinch fingers. Also, DO NOT drop
or bend the rangetop when raising or lowering. This could damage the surface.
Support
Bar
To Remove and Replace Burners for Cleaning
To Remove Burners
1. Remove shipping screws with a Phillips Head screwdriver. See illustration for
screw locations.
2. Tilt the burner at the end closest to the support bar until the Iocator tab is
released (front burners tilt right, rear burners tilt left). Move the burner toward
the back of the range. This will separate it from the gas valve at the front of
the range.
To Replace Burners
1. Slide the burner tube over the gas valve at the front of the range (front burners
fit over the right valve, rear burners fit over the left valve on each side of the
range).
2. Tilt burner so that the locating tab will slide into the slot on the support bar.
Make sure burners are properly seated on support bar and are level.
3. Replace shipping screws if desired.
DO NOT turn the burners on when the cooktop is raised for
cleaning. Be sure that the top is completely lowered and securely in place before
turning on the burners.
12
Loading ...
Loading ...
Loading ...