Loading ...
Loading ...
Loading ...
Electrical connection (continued)
3) The general purpose outlet is easily accessible with the
appliance installed.
In all cases, the power supply lead must be positioned so that it
does not reach a temperature 50°C above the room temperature.
An ideal route is shown in the 'Correct Installation' below. The
cable is guided by cable clips fixed to the side of the cabinet, in
order to avoid any contact with any appliance underneath the hob.
Replacing the power supply lead
If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person in
order to avoid hazard.
Before leaving
When the installation is complete, always check for gas leaks
using a soapy solution. Never use a flame to make this check.
Ignite all burners on high flame to ensure correct operation of gas
valves, burners and ignition. Turn gas taps to low flame position
and observe each burner to ensure they ignite completely at all
ports and that the flame is stable. Conduct these checks for each
burner individually and concurrently.
When satisfied with the hotplate, please instruct the user on the
correct method of operation. In case the appliance fails to operate
correctly after all checks have been carried out, please call the
Technika Service Centre.
Oven
Hotplate
Cable or
gas pipe
must not
contact
oven
Oven
Hotplate
Cable
clip
Gas
Supply
Pipe
Installation
15
Cable
clip
Correct
Installation
Incorrect
Installation
Loading ...