Loading ...
Loading ...
Loading ...
CAUTION:Beforeperformingany
serviceandadjustments:
Release control bar and stop engine.
Make sure the blade and all moving
parts have completely stopped.
Disconnect spark plug wire from spark
plug and place where it cannot come
in contact with plug.
LAWN MOWER
TO ADJUST cUTrlNG HEIGHT
See "TO ADJUST CUTTING HEIGHT" in
the Operation section of this manual.
DISCHARGE GUARD
The discharge guard, attached to the
discharge opening of your lawn mower, is
provided to prevent the possibilityof injury
resulting from objects being thrown out of
the discharge opening intothe operator
mowing position. Ifthe discharge guard
becomes damaged, it should be replaced.
REAR DEFLECTOR
The rear deflector, attached between the
rear wheels of your mower, is provided to
minimize the possibilitythat objects will be
thrown out of the rear of the mower into
the operator mowing position. If the
deflector becomes damaged, itshould be
replaced.
TO REMOVE/REPLACE DRIVE BELT
i emove drive cover. Remove belt by
pushing down on gear case pulley and
rollingbelt off it.
Tum lawn mower on its side with
carburetor and fuel cap up.
Remove blade.
Remove debris shield.
Remove belt from engine pulley on
crankshaft.
Install new belt by reversing above
steps.
Always use factory approved belt to
assure fit and long life.
Drive
cover
Push
down
TO ADJUST HANDLE
Your lawn mower handle can be raised or
lowered for your mowing comfort. Four
(4) positions are available: high, medium
high, medium low and low. Handles are
shipped mounted in the medium low
position.
To change from medium low to medium
high position, the upper and lower
handle sections will have to be turned
over.
Remove the cable clips.
Remove the controls and operator
presence control bar from the upper
handle.
Remove the starter rope guide from the
upper handle.
Remove hairpin cotters.
Disconnect the lower handle from the
handle brackets.
•Tum the handle over and reassemble
the hairpin cotters that have been
removed.
Reassemble the starter rope guide.
Reassemble the controls and the
operator presence control bar to the
upper handle.
_, CAUTION: Theoperatorpresence
control bar must pivotfreely to permit
blade/brake engagement when control bar
isreleased. Do not overtighten the
fasteners holdingthe controls tothe upper
handle.
Shipping Position
Medium low
Medium high
High
Low
14
Loading ...
Loading ...
Loading ...