Loading ...
Loading ...
Loading ...
Memory Location Scan Mode
During Memory Location Scan mode, the radio will rapidly
scan through all programmed memory channels. Whenever
any activity is detected on a channel, the radio will stop the
scan for 10 seconds to allow you to listen briefly on that
channel. It will then continue to scan unless you switch out of
Memory Location Scan mode.
NOTE
If there are fewer than two memory locations programmed
in the radio, the Memory Location Scan option will not
be available. At least two memory locations need to be
programmed to use the Scan button.
To Enter Memory Location Scan:
1. From Marine Standby mode, press the Memory/Escape
button.
2. Press and hold the DUAL WATCH/SCAN button.
The radio will immediately begin to scan all pre-assigned
memory channels. The SCAN and MEM icons will show on
the LCD.
3. A signal on any channel will stop the scan for
10 seconds to allow you to listen to the traffic
on that location.
4. Press the Channel Up or Channel Down button
to resume scanning the Memory Location Scan
channels or to change the scan direction.
5. To EXIT Memory Location Scan mode, press and hold the
DUAL WATCH/SCAN button again. The SCAN and MEM
icons will disappear from the LCD and the radio will return
to Memory mode.
VHF Marine Radio ProtocolsOperating Your Radio VHF Marine Radio ProtocolsOperating Your Radio
25
Nothing Comes Close to a Cobra
®
24
English
To Recall a Stored Memory Location:
1. Press the Memory/Escape button. The MEM icon will be
turned On.
2. Press the Channel Up or Channel Down button to select
the memory location. If a memory location has been
programmed, its associated channel will display on the
LCD. Your radio is now in Marine Standby mode on the
selected memory location.
To Exit Memory Location Mode:
Press the Memory/Escape button to return the radio
to Marine Standby mode. The last channel used in Marine
Standby mode will now be displayed on the
LCD and the MEM icon will disappear.
To Erase Stored Memory Locations:
1. Press and hold the Memory/Escape button for two
seconds. The memory location number will start flashing
and the MEM icon will be turned On.
2. Use the Channel Up and Channel Down buttons to advance
to the memory location you want to erase.
3. Press the Memory/Escape button to select the memory
location. The memory channel number will stop flashing
and the channel number will start flashing.
4. Use the Channel Up and Channel Down buttons to change
the channel to read “
--” at the selected memory location.
5. Press the Memory/Escape button to erase that memory
location.
Repeat steps 2 through 5 to erase as many additional memory
locations as you want.
6. Press and hold the Memory/Escape button for two seconds.
This will return the radio to Memory mode.
7. Press and release the Memory/Escape button again
to return to Marine Standby mode.
MEM Icon Memory Location Scan
ESC WEA
PWR
MEM
H-M-L
CHANNEL
MEM/ESC Button
PWR
MEM
CHANNEL
SC/DW
Scan Button
Advanced OperationAdvanced Operation
Loading ...
Loading ...
Loading ...