Loading ...
Loading ...
Loading ...
en Faults and what to do about them.
38
Faults and what to do about them.
Faults Cause/remedy
Water is leaking from the
appliance.
■ Attach the drain hose correctly or replace it.
■ Tighten the threaded joint on the inlet hose.
The appliance is not filling
with water.
Detergent is not being
dispensed.
■ Have you pressed the A button?
■ Is the tap turned on?
■ Could the filter be clogged? Clean the filter. ~ Page 35
■ Is the inlet hose kinked or trapped?
The door cannot be
opened.
■ The safety function is activated. Cancel the programme? ~ Page 30
■ Is $ selected (Rinse Hold = no final spin)? ~ Page 30
■ Can the door only be opened by the emergency release? ~ Page 36
The programme will not
start.
■ Have you pressed the A or Finished in button?
■ Is the door closed?
■ Is the E childproof lock activated? Deactivate. ~ Page 29
The drum briefly jerks or
judders after the
programme has started.
Not a fault – the internal motor test may cause the drum to jerk or judder briefly
when the wash programme starts.
The water is not draining. ■ Is $ selected (Rinse Hold = no final spin)? ~ Page 30
■ Clean the drain pump. ~ Page 34
■ Clean the drain pipe and/or the drain hose.
Water is not visible in the
drum.
Not a fault – the water is below the visible area.
The spin result is not
satisfactory.
Laundry wet/too damp.
■ Not a fault – the unbalanced load detection system has interrupted the spin
cycle because the laundry is unevenly distributed.
Distribute small and large items of washing in the drum.
■ Is Less Ironing selected (depending on the model)? ~ Page 23
■ Is the selected speed too low? ~ Page 22
The spin cycle runs
several times.
Not a fault – the unbalanced load detection system is adjusting an imbalance.
The programme is taking
longer than usual.
■ Not a fault – the unbalanced load detection system is adjusting an
imbalance by repeatedly distributing the laundry.
■ Not a fault – the foam detection is system active – a rinse cycle has been
switched on.
The length of the
programme changes
during the wash cycle.
Not a fault – the programme sequence is optimised for the specific washing
process. This may change the length of the programme shown on the display
panel.
Residual water in the
care-product
compartment i .
■ Not a fault – the effectiveness of the care product is not affected.
■ Clean the insert if necessary. ~ Page 27
Loading ...
Loading ...
Loading ...