Loading ...
Loading ...
Loading ...
5
*Operating your wine cooler
1) Turning on your wine cooler. Plug in and switch on the wine cooler by pressing on the power button
for a few seconds. When you use the wine cooler for the first time (or restart the wine cooler after
having it power off for a long time), there will be a few degrees variance between the temperature you
have selected and the one indicated on the LED readout. This is normal and it is due to the length of
the activation time. Once the wine cooler is running for a few hours everything will stabilize.
Important: If the unit is unplugged, power is lost or turned off, wait 3 or 5 minutes
before restarting the unit. The wine cooler might not start if you attempt to restart
before this time delay.
2) Operating noises. To reach the desired temperature settings, Euro wine coolers, like all wine coolers
operating with compressors and fans, may produce the following types of noises. These noises are
normal and occur as follows:
-Gurgling sound, caused by the refrigerant flowing through the appliance’s coils;
-Cracking/popping sounds, resulting from the contraction and expansion of the refrigerant gas to
produce cold;
-Fan operating sound, to circulate the air within the wine cooler.
3) Loading your wine cooler. You might load your wine bottles in single or
double rows while taking note of the followings: If you do not have enough
bottles to fill your wine cooler, it is better to distribute the load throughout the
wine cooler as 6 bottle arrangement so as to avoid” all on top” or “all below”
type loads.
-Do remove or relocate wooden shelves in the model E150WSCS to
accommodate large type of bottles or increase the capacity of the cabinet by stacking the bottles up
when necessary.
-Keep small gaps between the wall and the bottles to allow air circulation.
-Do not over load your wine cooler to facilitate air circulation.
-Do not stack more than 1.5 rows of standard 750ML bottles per shelves to facilitate air circulation
-Avoid obstructing the internal fan (located inside on the back panel of the wine cooler)
-Do not try to slide the shelves outwards beyond the fixed position to prevent the bottles from falling.
-Do not pull out more than one loaded shelf at a time as this may cause the wine cooler to tilt forward.
-Do not cover the wooden shelves with alloy foil or other materials, as it will obstruct air circulation
-Do not move your wine cooler while it is loaded with wines. The might distort the main cabinet.
*Temperature Setting
Notes: depending on the loading and settings chosen, it takes 24hours for the wine cooler to see the
temperature stabilizing. During this time LED seems to move erratically in particular dual-zone wine
coolers. It is normal process. This process occurs whenever the setting is modified and/or whenever a
Loading ...
Loading ...
Loading ...