Loading ...
Loading ...
Loading ...
RotatetheBuffer-Polisherasshownin Fig.4.Then
cover the same area again moving the Buffer-
Polisheras shownin Fig. 5. Repeatthis until you
havecompletedapplyingwaxto theentiresurface.
Whenapplyingwaxtoareaswhereonlypartialuseof
the polishingbonnetis possible,someexcesswax
will be thrownfromthe bonnet.SeeFig.6. NEVER
APPLY DOWNWARD PRESSURE ON YOUR
BUFFER-POLISHER.LET THE WEIGHTOF THE
TOOL DO THE WORK.APPLYINGDOWNWARD
PRESSUREON YOURBUFFER-POLISHERCOULD
RESULT IN MOTOR OVERHEATINGCAUSING
SERIOUSDAMAGE.NOTE:YOUAREAPPLYING
DOWNWARDPRESSUREWHENTHE POLISHING
HEADDOESNOTROTATE.
Whileyouarewaitingforthewaxtodryto ahaze,ap-
ply waxto acleancloth andapplybyhandto those
areasnot reachedby the Buffer-Polisher,such as
arounddoorhandles,headlights,andantenna.
WARNING:ALWAYS WEAR SAFETY GLASSES OR
EYE SHIELDS WHEN OPERATING YOUR BUFFER-
POLISHER. IF THE OPERATING IS DUSTY, ALSO
WEAR A FACE OR DUST MASK. FAILURE TO DO SO
COULD RESULT IN DUST OR LOOSE PARTICLES
BEING THROWN INTO YOUR EYES, RESULTING IN
POSSIBLE SERIOUS INJURY.
REMOVING WAX
Remove the first polishing bonnet and place the se-
cond polishing bonnet on your Buffer-Polisher with
the black side of the bonnet facing outward. See
Figure 7. To remove the wax move the slide switch to
the position marked "Hi" and follow the same pat-
tern you used to apply the wax. As you remove the
wax a fine dust will develop on the surface. After you
have completed removing all the wax use a clean dry
cloth to remove the dust. Use another clean dry cloth
to remvoe the wax from the areas where you applied
the wax by hand. NOTE: If you don't produce an im-
mediate shine, or if the wax doesn't come off easily,
either the wax hasn't dried completely, or you have
applied too much wax. If the wax hasn't dried com-
pletely, wait a few minutes before removing it. If you
have applied too much wax, work your Buffer-
Polisher back and forth as shown in Fig. 7.
BUFFING
Fig. 4
Fig. 5
Fig. 6
The buffing bonnet packed with your Buffer=Polisher can be used to produce a brighter finish. After you
have removed the wax and the fine dust from the surface, place the buffing bonnet on your Buffer-Polisher
with the lamb's wool facing outward. Place the Buffer.Polisher flat on the polished surface and move the
slide switch to the position marked "Hi". Rotate the Buffer-Polisher in the same manner as when applying
wax. Note: Do not apply downward pressure since applying downward pressure reduces the amount of
rotation of the polishing head.
Page 5
Fig. 7
Loading ...
Loading ...
Loading ...