Loading ...
Loading ...
Loading ...
,,=h= ,=., =111i =11 inlnll
TROUBLE SHOOTING CHART
,,H ,H ================= I,.H= = = i
TROUBLE SHOOTING CHART
SYMPTOM
Engine wilt not start or
will run only for a few
seconds after starting.
,,,,,,,,
Engine will not idle
properly.
Engine will not
accelerate, lacks
power, or dies
; under a load.
Engine smokes
excessively.
Engine runs hot,
Cutting attachment
moves at idle speed.
, ,,,,,,,, ,,,
Cutting blade stops
under a toad or does
not turn when the
engine is accelerated.
CAUSE
t. Fueltankempty
2. Engine flooded.
3. Spark plug not firing.
4. Fuel not reaching carburetor.
5. Carburetor requires adjustment,
6. Air filter dirty.
7, Fue! filter dirty.
8. None of the above,
1. Idle speed set too fast or too slow.
2, Carburetor requires adjustment.
3. None of the above.
,,,,,,,,,,,,.........
1. Air filter dirty.
2. Spark plug fouled.
3. Carburetor requires adjustment.
4. Muffler outlets plugged.
5. None of the above,
1. Air filter dirty.
2. Fuel incorrect.
3. Carburetor requires adjustment.
1. Fuel incorrect.
2, Carburetor set too low (lean).
3. Spark plug incorrect.
4. None of the above.
,, , , ,
1, Carburetor requires adjustment.
2. Throttle cable binding.
3. Clutch requires repair.
, , ,,, , ,,
1. Forcing blade into material being cut.
2. Blade clogged with debris.
3. None of the above.
REMEDY
1. Filltank withcorrect fuel mixture.
2. See "Starting Instructions."
3. Installnew plug/check ignitionswitch.
4. Clean fuel filter; inspectfuel line.
5. See "CarbUretor Adjustments."
6, Clean or replace air fiffer.
7. Contact your SEARS Service Center/Dept.
8. Contact your SEARS Service Center/Dept.
1. See "Carburetor Adjustments."
2. See "Carburetor Adjustments."
3. Contact your SEARS Service Center/Dept.
1. Clean or replace air filter.
2. Clean and re-gap or replace spark plug.
3. See "Carburetor Adjustments7
4. Contact your SEARS Service Center/Dept,
5, Contact your SEARS Service Center/Dept.
,,,,, ,, ,,,,, , ,,,J,,,,,,, ,,,,Li,,
1. Clean or replace air filter.
2. Refuel with correct fuel mixture.
3. See "Carburetor Adjustments."
1. See "Fueling Your Unit."
2. See "Carburetor Adjustments:'
3. Replace withcorrect plug.
4. Contactyour SEARS Service Center!Dept.
1. See "Carburetor Adjustments?
2. Contact yourSEARS Service Center/Dept.
3. Contact your SEARS Service Center/Dept.
,,,,, ,,,,,,,,,, ,
1. Cut at a slower pace.
2. Clean debris from blade.
3. Contact your SEARS Service Center/Dept.
If situations occur which are not covered in this manual, use care and good judgement,
ff you need assistance, contact your SEARS Service Center/Department or the
CUSTOMER ASSISTANCE HOTLINE at 1-800,235-5878.
-16-
Loading ...
Loading ...
Loading ...