Loading ...
Loading ...
Loading ...
SERVICE AND ADJUSTMENTS
• Start engine and move motion control lever until tractor
does not move forward or backward.
• Hold motion control lever inthat position and turn engine
off.
• While holding motion control lever in place, loosen the
adjustment bolt.
• Move motion control lever to the neutral (N) (lock gate)
position.
• Tighten adjustment bolt securely.
NOTE: Ifadditional clearance isneeded to get toadjustment
bolt, move mower deck height to the lowest position.
After above adjustment is made, if the tractor still creeps
forward or backward while motion control lever isin neutral
position, follow these steps:
• Loosen the adjustment bolt.
• Move the motion control lever 1/4 to 1/2 inch in the
direction it is trying to creep.
• Tighten adjustment bolt securely.
• Start engine and test.
• If tractor still creeps, repeat above steps until satis-
fied.
MOTION NEUTRAL
CONTROL _LOCK GATE
/" ADJUSTMENT
BOLT
FIG. 26
TO ADJUST STEERING WHEEL ALIGNMENT
If steering wheel crossbars are not horizontal (left to right)
when wheels are positioned straight forward, remove steer-
ing wheel and reassemble per instructions in the Assembly
section of this manual.
FRONT WHEEL TOE-IN/CAMBER
The front wheel toe-in and camber are not adjustable on
your tractor. If damage has occurred to affect the front
wheel toe-in or camber, contact your nearest authorized
service center/department.
TO REMOVE WHEEL FOR REPAIRS
(See Fig. 27)
• Block up axle securely
• Remove axle cover,retaining ring and washers toallow
wheel removal (rear wheel contains a square key - Do
not lose)
• Repair tire and reassemble
• On rear wheels only: align grooves in rear wheel hub
and axle Insert square key
• Replace washers and snap retaining ring securely in
axle groove
• Replace axle cover
NOTE: To seal tire punctures and prevent flat tires due to
slow leaks, tire sealant may be purchased from your local
parts dealer. Tire sealant also prevents tire dry rot and
corrosion.
WASHERS
AXLE COVER SQUARE KEY (REAR
WHEEL ONLY)
FIG. 27
22
Loading ...
Loading ...
Loading ...