1. Home
  2. Perlick
  3. Perlick 1443938 User Manual
  4. Page 12

Perlick 1443938 48 Inch C Series Panel Ready Wine Cooler Pair with HC24WB44L Left Hinge Glass Door Wine Cooler and HC24WB44R Right Hinge Solid Glass Wine Cooler

User Manual - Page 12

For 1443938.

PDF File Manual, 14 pages, Read Online | Download pdf file

1443938 photo
Loading ...
Loading ...
Loading ...
PERLICK RESIDENTIAL UNDERCOUNTER REFRIGERATION USE & CARE GUIDE
12 | perlick.com/residential
TOUCH-SCREEN CONTROL OPERATION - WINE MODELS
TROUBLESHOOTING
Iftheunitappearstobemalfunconing,readthroughthe
OPERATIONseconofthismanualrst.Iftheproblempersists,
checkthistroubleshoongsecontoseeifyoucanreferto
thecauseandremedyoftheproblemandresolveitwithouta
servicecall.



Problem Cause Solution
No interior light Bulb is loose • Tighten bulb
Bulb is burnt out • Replace bulb
LED board is inoperable • Contact Perlick Technical Service at
800-558-5592
Light stays on when door switch is closed Manual switch is on • Turn manual switch o
Door is not making contact with the door
switch
• Makre sure the door closes tightly
Noisy operation Soft sounds from compressor, fan motor and
valves heard
• Normal operation
“Crackling” sound during defrost • Normal operation
LED Controller display is ashing ”P1”* Thermostat probe has failed • Contact Perlick Technical Service at
800-558-5592
LED Controller display is ashing “P2”* Evaporator probe has failed • Contact Perlick Technical Service at
800-558-5592
LED Controller display is ashing “HA”* Internal compartment has exceeded the high
temperature alarm preset value for over 30
minutes.
• Make sure the door is completely closed.
• Check the door gasket seal. Replace if
necessary.
• Check the condenser and clean it if
necessary.
• Make sure the louvered plate is
unobstructed. If surrounding ambient
temperature has recently changed
dramatically, the compartment may be
aected.
• Make sure the interior light is o.
• Warm product was recently placed in the
cabinet. Wait 24 hours for the product to
chill and then recheck the temperature.
LED Controller display is ashing “LA”* Internal compartment has exceeded the low
temperature alarm preset value for over 30
minutes.
• Make sure the door is completely closed.
• Check the door gasket seal. Replace if
necessary.
• If the surrounding ambient temperature
has recently changed dramatically, the
compartment temperature may be
aected.
Unit is not running No power is going to the unit. • Home circuit breaker was tripped. Reset
the circuit breaker.
• ON/OFF keypad is turned o. Turn it on.
• If it is a Dual-Zone model, check the Dual-
Zone power switch (see page 4).
Condenser is dirty. • Clean the condenser
* Applies to Signature Series models only
DANGER!
Loading ...
Loading ...