Loading ...
Loading ...
Loading ...
PAGE: 3 / 12 PAGE: 4 / 12
NOTE: FOR OPTIMUM QUIETNESS, FULLY ASSEMBLE FAN AND RUN 24 HOURS
TOOLS AND MATERIALS REQUIRED
-
-
- Step Ladder
- Wire Cutters
- Wiring supplies as required by electrical code.
!
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
INSTALLATION AND WIRING TO BE IN ACCORDANCE WITH CEC,
NEC, LOCAL ELECTRICAL CODES and ANSI/NFPA 70.
Consult a qualified electrician if you are not familiar with wiring.
IMPORTANT SAFETY INSTRUCTIONS
WARNING
1. Turn off power at main electrical service box before starting installation.
2. Electrical connections must comply with local code ordinances, national electrical
codes, CEC, NEC and ANSI/NFPA 70.
3. Make sure the installation site you choose allows the fan blades to rotate freely
without any obstructions.
4. When mounting the fan on a ceiling outlet box, use an approved (CSA for Canada
and UL for U.S.) ceiling fan box marked "FOR FAN SUPPORT". Ensure the outlet
box is securely installed in place such that it is able to support at least the fan weight.
5. Total Fan Weight For Reference: 120"approximate 15.0 kgs (33.08 lbs).
1. TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR PERSONAL
INJURY, MOUNT TO OUTLET BOX MARKED ACCEPTABLE FOR FAN SUPPORT
AND USE MOUNTING SCREWS PROVIDED WITH THE OUTLET BOX. Most outlet
boxes commonly used for the support of lighting fixtures are not acceptable for fan
support and may need to be replaced. Consult a qualified electrician if in doubt.
2. Mount with the lowest moving parts at least 3.05 Meters (10 Feet) above floor or
grade level.
3. DO NOT operate reversing switch while fan blades are in motion. Fan must be
turned off and rotating blades stopped, reverse chain pulled, the speed chain
pulled again to start in the opposite direction.
Exploded View Detail
Mounting Bracket
Canopy
Downrod
Yoke Cover
Fan Motor
Fan Blades
Housing Cover
Phillips Screwdriver
Blade Screwdriver
Blade Bracket
① ON/OFF the fan
② Short press: ON/OFF the light
Long press(hold for 3 seconds): Dimming
③ Speed of the fan (①low speed —⑤high speed)
④ Direction of the fan (reverse switch)
⑤ Timing control of the fan
⑥ LED indicated light
⑦ 12V battery should be used in emitter
REMOTE
CONTROL
Loading ...
Loading ...
Loading ...