Loading ...
Loading ...
Loading ...
13. 3ΒΌ" x 10" Ducted Discharge Only: Remove _ from
damper flap and attach DampedDuct Connector over
knockout opening with screws removed in Step 4 under
"PREPARE THE HOOD". Make sure damper Pivot is
nearest to B/Back Edge of hood.
UP TO 1"
SIDE-TO-SIDE
ADJUSTMENT
14. 7" Round Ducted Discharge Only: Re-install 7" Round
Duct Ptate removed in Step #1 under "PREPARE THE
HOOD". Install a 7" round damper (purchase separately).
Damper flap must open freely in direction of airflow (away
from range hood).
_ To accomodate off-center ductwork, the Damped
Duct Connector can be installed up to 1-inch on
either side of hood center or the 7" Round Duct
Pmatecan be installed up to 1/2"on either side of
hood center. In extreme off-center installations,
one end of the duct connector may need to be
trimmed to cmearthe emectrical cable cmampo
15. Non-Ducted Installations Only: Require a
Performance Ring to be attached to the blower
wheel.
To install ring:
1. Remove the Blower Wheel by rocking it side
to side and applying a slight force to pull wheel
from motor. Remove Retainin Rg_g if
necessary.
2. Slide the ring onto the Small Diameter End of
the wheel and down to the _ of the
wheel.
3. Reassemble wheel to motor. Make sure Tab
on wheel fits into one of the Motor Smots.
4.
5.
Push wheel down until it is locked in place.
Check that wheel is properly positioned as
shown. Press Sections into place if necessary.
Make sure wheel turns freely.
TAPE
EDGE
TOP/BACK
DAMPER/
DUCT
CONNECTOR
.Vertical
d_scharge
oos_t_on snown)
WARNING: To reduce the risk of electric
shock, make sure power is switched off at the
service panel Lock or tag service panel to
prevent power from being switched on acci-
dentally.
1. Connect House Wiring (120 VAC) to hood. Use a piece of
Cardboard to protect the cooktop, if necessary.
A Cord Kit is available - which enables the hood to plug
into a standard 120 VAC wall outmet,
See page 4 for Cord Kit information,
Cord Kit avaiJabme by calling Sears
at 1-80O-4-MY=HOME _
Use only with range hood cord=connection
kite that have been investigated and found
acceptable for use with this modet range
hood.
10
iiiiii
!!!!i_i
HOUSE
WIRING
(120 VAC)
CARDBOARD
(Use to protect
ceoktop)
Loading ...
Loading ...
Loading ...