Loading ...
2/4
1
9
3
7
12
10
13
9
2
8
3
6
10
14
4
Using either the carriage handle 13 or the Iast slice device 4 push the product holder 3
back and forth to slice.
Always switch off the slicer and turn the slice thickness control clockwise to zero when not slicing.
CLEANING
This machine must be thoroughly cleaned after each day’s
operation or anytime it will not be used for an extended period
of time.
WARNING: UNPLUG MACHINE POWER CORD
AND TURN THE INDEX KNOB FULLY CLOCKWISE
BEFORE CLEANING THE SLICER.
Loosen the fixing screws and remove the slice deflector 12.
The product holder can be removed for an easy
cleaning rotating its handle counterclockwise 8
Using a mild soap and hot water solution and a clean cloth,
wipe all surfaces of the slicer.
Thoroughly rinse it with another clean cloth and fresh water.
Remove the blade cover removing the hand knob 7 .
When the slicer is not running, the
slicer thickness control 2 must be
set on zero (fuIly clockwise) to cover the
blade edge.
Always UNPLUG the power
cord before cleaning or moving
the slicer.
SLICING
PuII the product holder 3
towards you until it stops and place the
product to be sliced on the product
holder tray. Lay the last slice device
against the product and on the slicer
switch, press the pushbutton green or
red 9 .
Adjust the slice thickness rotating the
slice thickness control. The numbers
on the slice thickness control do not
indicate actual measurements but may
be used for reference to duplicate slice
thickness.
WARNING: THE SLICER BLADE IS VERY SHARP, USE EXTREME CAUTION WHEN WORKING
NEAR THE BLADE.
CAREFULLY wash both sides of the blade with the slice thickness control turned fully clockwise.
Wash the blade by wiping outward from the center.
ALWAYS rinse the blade thoroughly using fresh water and a clean cloth. Never use steel pads to clean
the blade. Wash and rinse the removed camponents before reassembling them.
DO NOT wash any slicer components in a dishwasher.
Loading ...
Loading ...