Loading ...
Loading ...
Loading ...
STOP BLOCK
See Figures 4 and 5.
The stop block is useful as a stop for cutting multiple
pieces to the same length. It can be installed on either
table extension on either side of the saw base:
• Slide the stop block on the back arm of either
table extension, then insert the table extension
into the saw base. See Figure 4.
• Use the large wing screws to secure the table
extensions to the saw base and the small wing
screw to secure the stop block to the table exten-
sion. See Figure 4.
• Loosen the small wing screw and adjust the stop
block the desired distance from the blade for the
cut to be made.
• Tighten small wing_screw securely.
• Make a test cut in scrap material and measure the
length of the workpiece.
• Make any necessary adjustments.
_1= WARNING: When using the work clamp with
the stop block, install the clamp on the stop block
side of the blade. This will eliminate the
possibility of the saw catching the loose end and
kicking up. Failure to heed this warning can
result in serious personal injury.
STOP
BLOCK
Fig. 5
Fortherepair orreplacementparts
youneeddelivereddirectlyto yourhome
Call7 am - 7 pm, 7 daysaweek
1-8OO-366-PART
(1-800-366-7278)
Forrepairservice
Call24 hoursaday,7 daysaweek
1-800-4-REPAIR
_(!-800-473-7247)
SEARS
America's Repair Specialists
Forthe location of a
SearsPads andRepairCenter
inyourarea
Call24 hoursaday,7 daysaweek
1-8OO-488-1222
Whenrequestingserviceor orderingparts,
alwaysprovidethe followinginformation:
• ProductName
10 inchCompound
Miter Saw
• ModelNumber
315.235360
• PartName • Part Number
4