Loading ...
Loading ...
Loading ...
Black (live)
White (neutral)
Bare/Green (ground)
Black
Blue
White
Green
Wire Connector
Warning: Do NOT use a
full-range dimmer switch to
control the fan speed.
Blade Screw
Blade Washer
Blade
Blade Arm
Mounting Screw
J-Slot
Lower
Bracket
Screw
Upper
Bracket
Screw
ASSEMBLY INSTRUCTIONS
5
8
7
6
5. Reinstall the previously removed lower bracket
screw and upper mounting screws to secure the lower
mounting bracket to the upper mounting bracket.
6
6. Use wire connectors to connect the fan wires to the
power supply wires according to the wiring diagram and
the following instructions:
• Connect the green wire from the lower mounting
bracket to the bare/green (ground) supply wire.
• Connect the white wire from the fan to the white
(neutral) supply wire.
• Connect the black and blue wires from the fan to the
black (live) supply wire.
Note: If there is a second live/hot wire coming from the
outlet box, connect it to the blue (light power) wire for
separate light and fan control,
Important: After the connections have been made, the
wires should be turned upward and pushed carefully
up into the outlet box. Place the black and white wire
connections on opposite sides of the outlet box.
7. Temporarily lift the motor housing up to the upper
mounting bracket to determine which two mounting
screws in the sides of the upper mounting bracket align
with the J-slots in the top edge of the motor housing.
Partially loosen the two mounting screws that align
with the J-slots. Remove the other two mounting
screws from opposite sides of the mounting bracket.
Slide the motor housing over the motor, aligning the
slotted holes in the motor housing with the loosened
mounting screws in the upper mounting bracket. Twist
the motor housing to lock. Then re-insert the two
previously removed mounting screws and securely
tighten all screws.
8. Partially insert the blade screws along with the blade
washers through the blade and into the blade arm.
Tighten each blade screw with a Phillips screwdriver (not
included), starting with the one in the middle. Repeat this
step for the remaining blades and blade arms.
Loading ...
Loading ...
Loading ...