Vase Fountain 1
Electric Submersible Pump 1
AC Adapter 1
MZ11336BE Page 1 / 1
CERAMIC VASE OUTDOOR WATER FOUNTAIN WITH LED LIGHTS
SSS-313
Read the assembly instructions carefully and follow the care instructions. Save these instructions for future reference.
ASSEMBLY
1. Connect the light cable that is built into the fountain to the short cable on the pump.
2. Connect the electric submersible pump to the tubing that is built into the fountain. Place the
pump inside the fountain and run the power cord from the pump through the opening in the
back of the fountain.
3. Firmly connect the pump power cable to the adapter.
4. Fill the fountain with enough water to keep the pump fully submerged during operation.
5. Plug the power cord into a properly grounded GFCI outlet.
Note: When rst used, there may be air in the pump. It may take several minutes for trapped air to escape, allowing water to ow.
09/2019
Thank you for choosing Sunnydaze Decor. We stand behind our brand and the quality of the items we
sell. Replacement parts or products will be sent at our discretion within the 1-year warranty period. Proof
of purchase, with the date of purchase as well as photos of the merchandise defect, must be provided.
Photos are used to determine the cause of defects and for future quality control. Register your warranty at
www.serenityhealth.com/warranty/
If you have any questions, comments or concerns, feel free to contact us by phone at 888-881-4668, by email:
customerservice@sere nityhealth.com, or via our contact us page at www.SerenityHealth.com/contact-us/
Purchase Date: / / Order/Customer Reference Number:
Inspect packaging to ensure all
parts are accounted for before
disposing of packaging.
IMPORTANT INFORMATION
USE & CARE
• For outdoor use only. Some splashing is normal; adjust the flow rate on the pump if the water rate is too high.
• Check the water level frequently to ensure the pump remains fully submerged; never allow the pump to run dry as it will burn out the motor.
• Only use water in this fountain. Distilled water will help prevent mineral buildup but is not required, avoid heavily chlorinated tap water as
it may damage the fountain or pump.
• Periodically change the water to keep the water, fountain and pump clean. Remove scale and buildup regularly.
DO NOT use harmful additives such as bleach, chlorine, etc.
DO NOT use a pressure washer or abrasive materials to wash the fountain
• Always shut off the power supply before cleaning and maintaining the fountain and the recirculating pump.
• Take care when handling the pump; only pick it up by the body of the pump, never by the power cord.
• During freezing weather, drain the fountain, disconnect the pump and store indoors; allowing ice to form may crack the fountain.
TROUBLESHOOTING
• Ensure that the pump is fully submerged and add water to the basin if necessary.
• Check the pump and tubing for obstructions.
• Check the flow control on the body of the pump as it may need to be adjusted to achieve the desired flow rate.
• If the light is not working, ensure the cables are fully connected and the seal is adequately tightened (do not over-tighten).
• If water is not flowing within several moments of the fountain being plugged in, unplug the power supply for a few moments and plug it back
in; the pump may have trapped air which can prevent water from circulating properly.
• Check to make sure the power outlet is working; if in doubt about electrical connections, consult a certified electrician.
