Loading ...
Loading ...
Loading ...
55
6.2.2: Removing the Programming / Data cable
Care must be taken when removing this cable. The cable is located between the main board
and the small 2” x 2” programming board. It is not recommended to use a metal tool to unsnap
the cable connector. Use of a metal tool could result in a static discharge or accidental damage
to the board.
1. The program board is connected to the main board by a row of pins on each side of the
board.
2. Grasp the program board on each side with your thumb and forefinger. Carefully pull
the program board out and away from the main board.
3. The data / programming cable can now be unsnapped and disconnected.
6.2.3: Re-Installing the Programming / Data cable
1. Carefully replace the data / programming cable back into the connection on the
program board.
2. Once again with care, align the pins on each side of the program board to re-adjoin with
the connections on the main power board.
Connector J16: See
Wiring, Section 9.1
Loading ...
Loading ...
Loading ...