Loading ...
Loading ...
Loading ...
11
RANGE HOOD CARE
Cleaning
IMPORTANT: Clean the hood and grease fi lters frequently
according to the following instructions. Replace grease fi lters
before operating hood.
Exterior Surfaces:
To avoid damage to the exterior surface, do not use steel wool
or soap-fi lled scouring pads.
Always wipe dry to avoid water marks.
Cleaning Method:
■ Liquid detergent soap and water, or all-purpose cleanser.
■ Wipe with damp soft cloth or nonabrasive sponge, then rinse
with clean water and wipe dry.
Metal Grease Filter
To Remove Metal Grease Filters:
1. Use two hands to remove the metal grease fi lters. Grasp
fi lter handles, push toward the rear of the range hood, and
pull down on the front handle to remove.
2. Repeat for each grease fi lter.
3. Grease fi lters should be cleaned using warm water,
dishwashing liquid, and a non abrasive brush. Dishwasher
not recommended.
To Reinstall Metal Grease Filters:
1. Grasp fi lter handles and place rear of fi lter into rear track.
2. Push down on the rear handle and set the front of the grease
fi lter into the front track to secure.
3. Repeat for each fi lter.
Replacing a LED lamp
Turn off the range hood and allow the LED bulb to cool. To avoid
damage or decreasing the life of the new lamp, do not touch
lamp with bare fi ngers. Replace lamp, using tissue or wearing
cotton gloves to handle bulb.
If new lamps do not operate, make sure the lamps are inserted
correctly before calling service.
1. Disconnect power.
2. Push up on the lens and turn it counterclockwise.
3. Remove the lamp and replace it with a 120 V, 6.5 W
maximum LED bulb with a GU10 base. Turn it clockwise to
lock it into place.
4. Repeat steps 2-3 for the other bulb if needed.
5. Reconnect power.
Loading ...
Loading ...
Loading ...