Loading ...
Loading ...
Loading ...
ASSEMBLY
Remove cardboard packing from seat pan and lift seat
pan to raised position.
Open battery box door.
Remove terminal protective caps and discard.
If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
• First connect RED battery cable to positive (+)terminal
with hex bolt, flat washer, lock washer and hex nut as
shown. Tighten securely.
• Connect BLACK grounding cable to negative (-) termi-
nal with remaining hex bolt, flat washer, lock washer
and hex nut. Tighten securely.
• Close battery box door.
Open battery box door for:
• Inspection for secure connections (to tighten hard-
ware).
• Inspection for corrosion.
• Testing battery.
• Jumping (if required).
• Periodic charging.
POSITIVE
(RED) CABLE
DISCARD
TERMINAL
PROTECTIVE
CAPS
LOCK
HEX WASHER
NUT
FLAT
NASHER
HEX
BOLT
NEGATIVE
(BLACK) CABLE
FIG. 2
SEAT
PAN
BOX DOOR
FIG. 3
INSTALL SEAT (See Fig. 4)
Adjust seat before tightening adjustment bolt.
• Remove cardboard packing on seat pan.
• Place seat on seat pan and assemble shoulder bolt.
Assemble adjustment bolt, Iockwasher and flat washer
loosely. 'Do not tighten.
Tighten shoulder bolt securely.
• Lower seat intooperating position and sit on seat.
• Slide seat untila comfortable positionis reached which
allows you to press clutch/brake pedal all the way
down.
• Get off seat without moving its adjusted position.
• Raise seat and tighten adjustment bolt securely.
SEAT PAN
SHOULDER
BOLT
LARGE FLAT
WASHER
ADJUSTMENT LOCKWASHER
BOLT
FIG. 4
ASSEMBLE GAUGE WHEELS TO MOWER
DECK (See Fig. 5)
Assemble gauge wheels with tractor on a flat level surface.
• Adjust mower to desired cutting height (See 'q-O AD-
JUST MOWER CUFFING HEIGHT" in the Operation
section of this manual).
• With mower in desired height of cut position, gauge
wheels should be assembled so they are slightly off the
ground. Install gauge wheel in appropriate hole with
shoulder bolt, 3/8 washer, and 3/8-16 Iocknut and
tighten securely.
• Repeat for opposite side installing gauge wheel in
same adjustment hole.
GAUGE WHEEL
MOUN_NGBRACKET_._.
SHOULDER BOLT
FIG. 5
7
Loading ...
Loading ...
Loading ...