Loading ...
Loading ...
Loading ...
SERVICE AND ADJUSTMENTS
TO START ENGINE WITH A WEAK BA'n'ERY
(See Fig. 32)
CAUTION: Lead-acid batteries gener- I
ate explosive gases. Keep sparks, flame
I
and smoking materials away from bat-
teries. Always wear eye protection
when around batteries.
If your battery is too weak to startthe engine, itshould be
recharged. If "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12
VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER
VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE
GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR
BATTERY TO START OTHER VEHICLES.
TO ATFACH JUMPER CABLES -
• Connect each end of the RED cable tothe POSITIVE
(+) terminal of each battery, taking care not to short
against chassis.
• Connect one end of the BLACK cable to the NEGA-
TIVE (-) terminal of fully charged battery.
Connect the other end of the BLACK cable to good
CHASSIS GROUND, away from fuel tankand battery.
TO REMOVE CABLES, REVERSE ORDER -
BLACK cable first from chassis and then from the fully
charged battery.
RED cable last from both batteries.
POSITIVE TERMINAL NEGATIVE TERMINAL
CABLES
CHARGED
BATTERY
POSITIVE NEGATIVE
TERMINAL TERMINAL
TO REPLACE HEADLIGHT BULB
• Raise hood.
• Pull bulb holder out of the hole in the backside of the
grill•
Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
• Close hood.
INTERLOCKS AND RELAYS
Loose or damaged widng may cause your tractor to run
poody, stop running, or prevent it from starting.
• Check wiring. See electrical wiring diagram in the
Repair Parts section of this manual.
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-in fuse. The
fuse holder is located behind the dash.
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 33)
• Raise hood.
• Unsnap headlight wire connector.
Stand infront oftractor. Grasp hood at sides, tilttoward
engine and tilt off of tractor.
• To replace, reverse above procedure.
HOOD
HEADLIGHT WIRE
CONNECTOR
FIG. 33
FIG. 32
24
Loading ...
Loading ...
Loading ...