Loading ...
Loading ...
Loading ...
Section 4 - ADJUSTMENT & REPAIR
WARNING
DO NOT attempt any adjustments, maintenance or
service with the engine or blades running. STOP
blades. STOP engine. Set brake. Remove key.
Remove spark plug wire from spark plug and secure
wire away from spark plug. Engine and components
can be extremely hot. Avoid burns by allowing engine
and components sufficient time to cool.
SIDE
SHOWN
DECK HANGER......
FRONT
4.4.7. TRACTION DRIVE BELT REPLACEMENT
48" Mower Deck Removal
RemoveItis necessarydeck asto follows:remove deck in order to replace belts.
1. Place tractor on a firm, level surface such as a
driveway or garage floor and set the park brake.
2. Turn engine "OFF". Remove key.
3. Lower the deck to lowest setting.
4. Disconnect the front lift rod assembly from the
front hanger bracket. See Figure 4.25.
5. Remove hair pins from the front deck hanger
rod and slide out the rod from deck hanger bracket.
Front lift arms will be now be disconnected. See
Figure 4.26.
FRONT DECK"
HANGER ROD
FRONT
LIFT ARM
FIGURE 4.26
ELECTRIC
CLUTCH
BELL CRANK
HAIR PIN LIFT
LEVER
LIFT ROD
, CLEVIS
FIGURE 4.27
(Continued On Next Page)
DECK
DRIVE
BELT
48" DECK SHOWN
FIGURE 4.25
6. Turn the front wheels to the left.
7. Hold front of deck "UP" and slide the front deck
hanger rod to the right and out then lower the front of
deck to the ground.
8. Remove deck drive belt from engine pulley
bottom groove. See Figure 4.29.
26
Loading ...
Loading ...
Loading ...