Loading ...
Loading ...
Loading ...
Section 3 - MAINTENANCE
3.3
3.2.4. CHECK DECK DRIVE BELT
1. The idler and spring provide proper belt tension and
require no adjustment. If belt is frayed, slit, severed or
belt strands exposed, replace belt before operating
mower.
SERVICE - EVERY 25 OPERATING HOURS
3.3.1. CHECK ENGINE
1. Change engine oil. Refer to Section "CHANGE
ENGINE OIL". Change engine oil filter (if equipped).
Refer to engine owner's manual for oil and filter
specification.
2. Remove and clean engine air pre-cleaner. See
Figure 3.4. Refer to engine owner's manual for
cleaning instructions.
3. Remove and replace engine air cleaner. Refer to
engine owner's manual for service instructions.
___ _ "COVER RETAINING
._,w _ KNOB
_--.- AIR CLEANER COVER
CARTRIDGE ELEMENT
PRE-CLEANER
STUD
AIR CLEANER BASE
SINGLE CYLINDER ENGINE TYPE "
AIR
3.3.2. MOWER COMPONENTS
1. Check deck drive belt for proper tension. Refer
to Section, "CHECK DECK DRIVE BELT".
2. Check blades for sharpness, wear, damage and
torque. Refer to Section on "MOWER BLADE
SERVICE".
3. Check mower deck for proper levelness. Refer
to Section "MOWER DECK ADJUSTMENT
LEVELNESS".
4. Clean mower deck.
a. Remove key from ignition switch.
b. Remove deck.
c. Clean underside of mower deck, removing all
accumulation of grass clippings and debris.
d. Clean top of deck, removing all grass clippings
and debris.
5. Lubricate spindles with 1 to 3 shots of general
purpose grease from grease gun.
IMPORTANT - 48" DECK ONLY:
Spindles on 48" deck must be kept filled with
grease, Apply grease from grease gun until
grease purges from vent located underneath
deck on spindle housing,
6. Lubricate all mower deck linkage pivot points
with a light coat of motor oil.
3.3.3. CHECK BLADE BRAKE
1. Refer to Section "CHECK BLADE BRAKE".
3.3.4. TRACTOR LUBRICATION
1. Front Wheel Bearings
Lubricate each front wheel bearing through the
grease fitting on wheel hub. Using general purpose
grease in a grease gun, add grease until grease
purges from bearing. See Figure 3.5.
PRE-CLEANER
L RET_NING PLATE
t_..,_AIR CLEANER COVER
RETAINING CLIPS
i TWIN CYLINDER ENGINE TYPE
FIGURE 3.4
SPINDLE
LUBRICATION
FITTING
BEARING LUBRICATION
FITTING
FIGURE 3.5
2. Axle Spindles
Lubricate each axle spindle with 1 to 3 shots of
general purpose grease. See Figure 3.5.
(Continued On Next Page)
13
Loading ...
Loading ...
Loading ...