Loading ...
Loading ...
Loading ...
Features Cycle Sic_ Ccmtrol (soroe models)
When the Cycle Signal Control is ON, a signat will sound at the end of each cycle
and during the PressSaver setting (some models) The volume is adjustable on
some models
Place the front bar under
the lip of the lint screen opening
Dram1 Light (sc_a tmaels)
A drum light will come on whenever the door is opened to illuminate the dryer
drum during loading and unloading Closing the door turns off the light
Reversible Dryer Door
Your dryer isequipped with a reversible door The door can be hinged on the right
or left side Refer to the INSTALLATIONiNSTRUCTiONSfor directions on changing
the door
Drying Rack (scme models)
Use the drying rack to dry items which should not be tumble dried
1 Open the dryer door and remove the lint screen
2 insert drying rack into the dryer drum Place the front bar under the lip of the
lint screen opening
3 Place items to be dried on top of the rack Weight should not exceed 10 Ibs
Leavespace between items, but do not let items hang over the sidesor through
the grids Do not tumble other items when using the drying rack
4 Setect atimed dry setting best suited for items being dried Useonlythe Air Ruff
(no heat) temperature setting for items containing plastic, foam rubber,
rubber-like materials, feathers or down
5 When items are dry, remove the rack and replace the lint screen If lint screen
is not in place, tumbling items could enter the exhaust system and cause
damage to the dryer
Common DrH Problems
Many drying problems involve poor cleaning results, poor soil and stain removal, residues of lint and scum, and fabric damage
For satisfactory drying results, follow these suggestions provided by The Soap and Detergent Association
PROBLEM
(measy, oily
stains
Lf_
PJ]lir_
(Fibersbreak
off, ball up and
cling to fabric,)
Shrinking
Wrinkling
POSSIBLE CAUSES SOLUTIONS
PREVENTIVE MEASURES
• Fabric softener sheet,
• Rub fabric softener stains with bar soap
Rinse and rewash
• Add a few bath towels to small loads for
proper tumbling
• Some silkdike fabrics should be air dried,
• Use proper drying temperature,
• Place fabric softener sheet on top of load
before starting the dryer,
• Overloading,
• Overdrying causes static
electricity
• Lint screen not clean
when cycle began,
• Lint is attached to pills"
• Reduce load size and rewash using liquid
fabric softener in the final rinse
• Or, add a fabric softener sheet and
tumble without heat
• Use lint brush or roller to remove lint
• Do not overload dryer
• Use fabric softener in washer or dryer to
reduce static electricity
• Remove items when they are slightly damp
to avoid everdrying
• Check that lint screen is clean and in place,
Pilling is normal with
synthetic and permanent
press fabrics This is due
to abrasion from normal
• Use a lint brush or shaver to remove pills,
• Use fabric softener to lubricate fibers,
• When ironing, use spray starch or fabric
finish on collars and cuffs
• Turn items inside out to reduce abrasion
wear
Overdry[ng,
• Irreversible condition,
• Follow fabric care label directions,
• If shrinking is a concern, check load often
• Remove items while slightly damp and
hang or lay flat to complete drying,
• Block knits into shape,
• Overloading,
• Leaving items in dryer
after cycle ends
• Reduce load size and tumble at medium • Do not overload dryer
or low heat for 5-10 minutes • Remove items as soon as cycle ends
• Remove items immediately Hang or fold
Loading ...
Loading ...
Loading ...