Loading ...
Before beginning assembly, installation, or operation of product, make sure all parts are present. Compare
parts with package and hardware contents list on page 1. If any part is missing or damaged, do not attempt to
assemble, install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Philips screwdriver or screwgun with Philips bit (surface mount)
or power drill with 2-3/8” hole saw (recess mount), measuring tape, pencil and safety glasses. Estimated
assembly time: 10 minutes
SAFETY INFORMATION
PREPARATION
WARNING:
These products may represent a possible shock or re hazard if improperly installed or
attached in any way. Products should be installed in accordance with these instructions, current electrical
codes, and/or the current National Electric Code (NEC). Disconnect power to the unit prior to installation.
WARNING: To reduce risk of re, electric shock, or injury to persons,
• Always be sure that power supply is turned off at fuse box or circuit breaker before installing, cleaning, or
servicing the xture.
• Do not turn on xture with missing or damaged lens.
• There are no serviceable parts inside the xture.
• If attached to a movable cabinet, route and secure cords so that they will not be pinched or damaged
when the cabinet is pushed to the wall.
• Suitable for surface or recessed cabinet installation. Not intended for recessed installations in ceilings or
softs.
• Suitable for indoor dry locations only. Do not install over a sink.
• Use only with 120V AC plug-in power cord supplied with the light. Do not alter power cord in any manner.
• The National Electric Code (NEC) does not permit cords to be concealed where damage to the cord’s
insulation may go unnoticed. To prevent re damage, do not run cord behind walls, ceilings, softs, or
cabinets where it may be inaccessible for examination. Cords should be visually examined periodically
and immediately replace when any damage is noted.
• Do not touch hot lens.
• Keep xtures away from curtains and other combustible materials.
WARNING: Injury to persons and damage to the xture and/or mounting surface may result if the xture
is pulled from the surface. To reduce the likelihood of such injury or damage, mount to a surface that is
mechanically sound. The mounting surface must be at least 1/2 inch thick. This product is designed to be
mounted to the underside of a horizontal surface such as the bottom of a cabinet or shelf.
SAVE THESE INSTRUCTIONS. For safest operation, read and become familiar with complete
installation instructions prior to use. Pay close attention to this manual and stay within its guidelines when
using this product.
CAUTION:
• If you have any doubts about how to install this lighting xture, or if the xture fails to operate completely,
contact a qualied licensed electrical contractor.
• All parts must be used as indicated in this manual. Do not substitute any parts, leave parts out, or use
parts that are worn out or broken. Failure to obey this instruction could invalidate the ETL certication.
• This xture has a polarized plug (one blade is wider than the other) as a safety feature. This plug can be
used in a polarized outlet only one way. If the plug does not t fully in the outlet, reverse the plug. If it still
does not t, contact a qualited electrician. Never use with an extension cord unless the plug can be fully
instered. Do not alter the plug.
• Not for use with plastic furniture.
• Do not mount over a sink or stove.
• LEDs emit bright light. Avoid looking directly at the light source.
• This xture is not linkable.
2
Loading ...
Loading ...