HME030363N User Manual

Loading ...

Choose the right cable size



fuse, and switch needed is determined by the

maximum current of the unit. The maximum

current is indicated on the nameplate located on

the side panel of the unit. Refer to this nameplate

to choose the right cable, fuse, or switch.

1. Open the front panel of the indoor unit.

2. Using a screwdriver to open the wire box cover

on the right side of the unit. This will reveal

the terminal block.

Terminal block

Wire cover

Screw

Cable clamp

WARNING





LOCATED ON THE BACK OF THE INDOOR UNIT’S

FRONT PANEL.

3. Unscrew the cable clamp below the terminal

block and place it to the side.

4. Facing the back of the unit, remove the plastic

panel on the bottom left-hand side.

5. Feed the signal wire through the slot, from the

back of the unit to the front.

6. Facing the front of the unit, connect the wire

according to the indoor unit’s wiring diagram,



to its corresponding terminal.

CAUTION



dangerous, and can cause the air conditioning unit

to malfunction.

7. After checking to make sure every connection

is secure, use the cable clamp to fasten the

signal cable to the unit. Screw the cable clamp

down tightly.

8. Replace the wire cover on the front of the unit

and the plastic panel on the back.

NOTE ABOUT WIRING





Step 7: Wrap piping and cables

Before passing the piping, drain hose, and the

signal cable through the wall hole, you must bundle

them together to save space, to protect them and

insulate them (Not applicable in North America).

1. Bundle the drain hose, refrigerant pipes, and



Indoor Unit

Space behind unit

Refrigerant piping

Drain hose

Signal wire

Insulation tape



Make sure that the drain hose is at the bottom of

the bundle. Putting the drain hose at the top of the







WIRES

While bundling these items together, do not

intertwine or cross the signal cable with any other

wiring.

2. Use adhesive vinyl tape to attach the drain

hose to the underside of the refrigerant pipes.

3. Use insulation tape to wrap the signal wire,

refrigerant pipes, and drain hose tightly

together. Double-check that all items are

bundled.

Installation

Loading ...

hOmeLabs HME030363N Split Type Inverter Air Conditioner with Heat Function — 9,000 BTU 230V — Low Noise, Multimode Air Conditioning with a Washable Filter, Stealth LED Display, and Backlit Remote Control

User Manual - Page 33