Loading ...
Loading ...
Loading ...
29
Installation
INDOOR UNIT INSTALLATION
PRIOR TO INSTALLATION
Before installing the indoor unit, refer to the label
on the product box to make sure that the model
number of the indoor unit matches the model
number of the outdoor unit.
Step 1: Select installation location
Before installing the indoor unit, you must
choose an appropriate location. The following are
standards that will help you choose an appropriate
location for the unit.
Proper installation locations meet the following
standards:
•
• Convenient drainage
Noise from the unit will not disturb other
people
• Firm and solid—the location will not vibrate
• Strong enough to support the weight of the unit
• A location at least one meter from all other
electrical devices (e.g., TV, radio, computer)
DO NOT install unit in the following locations:
• Near any source of heat, steam, or combustible
gas
•
clothing
• Near any obstacle that might block air
circulation
• Near the doorway
• In a location subject to direct sunlight
While choosing a location, be aware that you
should leave ample room for a wall hole (see
Drill wall hole for connective piping step) for the
signal cable and refrigerant piping that connect
the indoor and outdoor units. The default position
for all piping is the right side of the indoor unit
(while facing the unit). However, the unit can
accommodate piping to both the left and right.
Refer to the following diagram to ensure proper
4.75in
or more
90.55in or more
4.75in
or more
5.9in or more
The mounting plate is the device on which you will
mount the indoor unit.
• Take out the mounting plate at the back of the
indoor unit.
• Secure the mounting plate to the wall with
the screws provided. Make sure that mounting
Note: If the wall is made of brick, concrete, or
similar material, drill 0.2in-diameter holes in the
wall and insert the sleeve anchors provided. Then
secure the mounting plate to the wall by tightening
the screws directly into the clip anchors.
Loading ...
Loading ...
Loading ...