Loading ...
Loading ...
Loading ...
6
GAS CONNECTION
This appliance must be installed by an authorised person in accordance with this instruction manual
AS/NZS 5601.1 – Gas installations (installation and pipe sizing), local gas fitting regulations, local
electrical regulations, Building Code of Australia and any other government authority.
Ÿ The connection must be performed by an authorised person according to the relevant
standards.
Ÿ This appliance is suitable for use with Natural Gas or ULPG. The gas range is shipped from
the factory set and adjusted for Natural Gas. It can be converted for use with ULPG
following the instructions in this manual.
Ÿ The connection must be made at the rear of appliance. Ensure the pipe does not cross the
cooker.
Ÿ The inlet not used must be closed off with the cap and sealing gasket supplied.
Ÿ The gas connection is male ½” BSP female thread (in compliance with ISO 7 thread) and is
situated 55mm from the right and 560mm from the floor.
Ÿ Ensure the hose is long enough to allow for removal of the appliance for servicing. The hose
assembly must be AS/NZS 1869 Class B or D certified. The hose assembly must be no
longer than 1.2 m in length with minimum internal diameter of 10 mm and comply with
relevant AS 5601 / NZS 5261 requirements. The hose must not be kinked, subjected to
abrasion or permanently deformed. The hose must not be near or in contact with any hot
surfaces (e.g. base of metal hotlplate, flue, or chassis of underbench oven etc.)
IMPORTANT! Check the correct positioning of the gas regulator. The arrow on the back of the
gas regulator must be oriented toward the connector.
Loading ...
Loading ...
Loading ...